Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

New application for an Impact Driver.....

Posts

New application for an Impact Driver.....

#1

New application for an Impact Driver.....

Barry Irby

There has been lots of discussion abut Impact Drivers and using them to drive screws and bolts and whether they allow fine control etc.

Yesterday I stepped on a drywall screw while putting up some small pieces of drywall. Went through the sole of my running show and was sticking me in the foot. I was able to sort of pinch the sole of he shoe and keep it from sticking me with one hand but could not pull it out with the other. So, I used the Impact Driver to unscrew the screw. Now that I think about it, I might have been able to take the shoe off, but when you are standing there one foot with a screw in your other foot and a handing Impact Driver, it seemed like a good idea. And it worked well.

Re: New application for an Impact Driver.....

#2

Yikes

John K Jordan

Make sure the direction switch is set correctly...

Re: New application for an Impact Driver.....

#3

Re: New application for an Impact Driver.....

Mark Nowicki

I swear Barry, every time I read your posts I feel I should make popcorn...:-)

Re: New application for an Impact Driver.....

#4

Re: Yikes

Barry Irby

I checked direction it at least three times, said a little prayer, and still started very slowly.

Re: New application for an Impact Driver.....

#5

Re: New application for an Impact Driver.....

Yonak

Just wondering for future reference .. would an Impact Driver still be the appropriate tool if the screw had gone through the foot ?

Re: New application for an Impact Driver.....

#6

Re: New application for an Impact Driver.....

AZ in Colorado Springs

That's better than the back end of a claw hammer. That'd be like yanking a fish hook out, but with more barb type thingys.

Re: New application for an Impact Driver.....

#7

Re: New application for an Impact Driver.....

Barry Irby

I don't want to find out. I suppose I could have sat down and tried to take the shoe off, but the screw was angled toward the toes, making that seem unlikely at the moment. Hopping around on one foot while holding the shoe in one hand and the Impact Driver in the other, it just seemed like the tool for the job. Fast.