A screwdriver that fits brass slotted screws
Bill Tindall, E.Tn.
If the bit has parallel sides and snugly fits the slot, messing up the slot in a brass screw becomes easy to avoid. It is annoying (and bewildering) that finding a screwdriver to fit brass slotted screws is difficult. I recently needed something to fit a #3 screw for the hardware on the Spice Box. Exasperated, I tried, with surprising success, to make one.
I have many more slotted bits that I ever imagine needing so screwing one up in this exercise was not a concern. Maybe because I didn't care made the job easy. I used the bench grinder with the wheel I use for sharpening, and just started slowly grinding away the bit until it fit the screw slot snugly. I was careful to keep the sides parallel to match the profile of the screw slot.
I mounted the bit in one of the magnetic thingyies that go in a drill to hold screw bits. It works grand. I will not hesitate to grind another should I need a bit of some particular size.



