Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Frustration with warped material, *LINK*

Posts

Frustration with warped material, *LINK*

#1

Frustration with warped material, *LINK*

Keith Newton

I'm finally getting started on building that 12' long kitchen island which will be veneered with some very nice figured Bubinga. I've made one modification since the earlier post, by lowering the work side to 36", and raising the bar-top to 42".

The builder has specified that I use Extira for the substrate, which would be fine with me, since there is a sink in it. When I went to pick up materials, the bundle that my supplier had pulled for me was so warped that I wouldn't accept it.

Then we went back to get a new bundle, and cut the bands on it. It had been sitting on a level floor, and showed no reason for the whole bundle also being warped. Every sheet had 1.25" bow down the long side, and 7/16" across the short axis, creating a bulge.

I'm wondering if I should expect the face veneers to hold this amount of bulge out?

I don't have any extra veneer to do the project over, if it just comes out curved again.

I always thought one of the wonderful things about mdf products were that we could always expect them to be flat.

My local supplier says he hasn't had any complaints, and that he even has one shop using it for exterior doors.

Seems like life is hard enough without having to fight problems like this. Not to mention that with a price over $50 per sheet, flatness would be nice.

What do you think? Are any of you regular users of Extira, and is it always warped when you get it?


https://www.flickr.com/photos/7391658@N03/albums/72157655710651965