Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Report on Lee Valley brad point drill bits

Posts

Report on Lee Valley brad point drill bits

#1

Report on Lee Valley brad point drill bits

Bill Tindall, E.Tn.

Over the years I bought various sizes of brad points as needed, but there was always some task that came up where I lacked the ideal size. I bought a set of foreign made bits and promptly returned them. They were ground so poorly as to be useless. Tempted by a free shipping offer I sprung for the leave your knees weak priced LV set. I had watched them being made on a LV factory tour and that may have added to the free shipping temptation. Yet I still wondered if I had squandered too much money on the set.

A couple of recent builds required a bunch of drilling and in one case blow out on the reverse side of a finished door would have been fatal. I found that the LV bits drilled quickly and the grind lessened the propensity of the drill to bust out of the exit hole. In fact, just holding a block of wood against the exit was typically sufficient to prevent splintering as the bit exited the back side. They performed better than any previous bit I had bought. (I saw a German bit demonstrated at the IWF show that appeared to be exceptional too, but I have no idea where to buy them.)

The LV bits are made from high speed steel, probably M2, a highly abrasion resistant steel, so the pointy points should stay sharp for a while. It is unclear how readily a dulled drill can be sharpened. You won't touch up M2 steel with a file like some brad points. If you expect to do wood working long enough to justify the expense of a set I would recommend buying the set. As you use them you will probably fee better about the cost.

Re: Report on Lee Valley brad point drill bits

#2

Re: Lee Valley brad point drill bits

Rum

Amen!

I never thought I'd say that a set of drill bits was one of my best purchases but these are beyond a doubt up there. Really improves confidence about your ability to make a clean hole.

Re: Report on Lee Valley brad point drill bits

#3

Re: Report on Lee Valley brad point drill bits

Thomas Skaggs, Foothills of Mount Level

I have used a set of LV brad point bits for years. They are a great value for the quality.

T.

Re: Report on Lee Valley brad point drill bits

#4

Re: Report on Lee Valley brad point drill bits

paul-in-plymouth

I agree. The HSS Lipped Brad Points from LV are great - they cut cleanly, and the points actually coincide with the axis of rotation. Lack of concentricity in my old cheapie set first drove me up the wall and then drove me to splurge on these from LV. I’ve never been sorry. They are well worth the price.

LV does offer a subset of most frequently used sizes, if the price of the full 28-bit set is a barrier. On the other hand, I’ve had the full set since 2010 and find I have used all but two of the bits in that time. After 5 years with no sharpening, all still cut very cleanly.

LV also sells what they call “Utility” brad points made of HCS. I have not tried these.

Re: Report on Lee Valley brad point drill bits

#5

Jim DeLaney, Austintown, Ohio

Re: Report on Lee Valley brad point drill bits

Jim DeLaney, Austintown, Ohio

Been using them for several years, and they're the best brad-points I've ever used - at any price.

Also very good are LV's HSS Forstner bits. I have quite a few of them, and they're as good or better than the Fisch (German) bits from years ago.

Re: Report on Lee Valley brad point drill bits

#6

Re: Report on Lee Valley brad point drill bits

Alexandre Grigoriev

I think you can touch those with a diamond file.