Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Elu 3338 router problem

Posts

Elu 3338 router problem

#1

Elu 3338 router problem

Dave Smith

My Elu 3338 router began losing speed with or with out a load. Some times the speed will ramp back up without a load. Turning the router off will return it to set speed when restarted. The motor is not hot. I blew out accumulated dust and wood chips with no effect. I am thinking brushes or the speed control. Any suggestions?

Dave Smith

Still breaking things in Longview, WA.

Re: Elu 3338 router problem

#2

Ellis Walentine

Had a similar problem

Ellis Walentine

... with a Freud router. Contacted them and they installed a replacement speed control. This is the same router as the DeWalt line, so those guys may be able to assist you. Not much more help here.

I'm glad to hear from you, Dave.

Cheers,

Ellis

Re: Elu 3338 router problem

#3

Re: Had a similar problem

Dave Smith

Thank you Ellis. The router is about 20 years old so I will have to fix it myself.

I have not around for a while. Life just happens.

Dave Smith

Fixing stuff in Longview, WA.

Re: Elu 3338 router problem

#4

Speed controler obsoulete. !#%


Re: Elu 3338 router problem

#5

Re: Elu 3338 router problem

del schisler

wire around the speed control , than you can use the router at full speed , at least it won't be a dust collector

Re: Elu 3338 router problem

#6

I have the same router....

Brian Roberts

"wire around the speed control" ..........is not at all practical.....but not impossible I suppose.

Re: Elu 3338 router problem

#7

Re: Elu 3338 router problem

Brian Roberts

The pc board...which is the speed control....is available here:

http://www.ereplacementparts.com/pc-board-p-68954.html?osCsid=14ks82un7nf7ia7apscl6a2935

So are the brushes and the switch....same place.

Re: Elu 3338 router problem

#8

Re: Speed controler obsoulete. !#%

Dick Coers

I would have thought a Dewalt 625 controller would have worked.

Re: Elu 3338 router problem

#9

Thank you

Dave Smith

I think I looked at that site and read right over the compatibility list. Thanks for pointing out my over sight. It is a great router I have had over 20 years and this is the first problem.

Woodcentral comes through again.

Dave Smith.

Learning to read in Longview, WA.

Re: Elu 3338 router problem

#10

Worth trying this.....

Brian Roberts

Dave....remove the outer cover....then the control board....turn the board upside down (remove dial) and you will see the potentiometer that controls the speed. Everything internally is exposed to the huge amount of dust that flows thru the router along with the cooling air.

You have nothing to lose by trying to use a good quality contact cleaner (DeoxIT is a good one) to clean the speed pot. Spray....turn from limit to limit several times....allow to soak....spray some more....turn dial some more....etc. ...several times...then allow to dry and give it a try.

Re: Elu 3338 router problem

#11

Re: Worth trying this.....

Walt

And while you're looking at the speed control, check for bad capacitors. They look like tiny cans usually. Certain P-C router speed controllers were known for failing and capacitors were one reason. There was a spate of premature PC motherboard failures in the late '90's (or thereabouts) for the same reason - caps that failed prematurely.

You can wire around the internal speed control and use an external speed controller if you need speed control. I'm sure the external controllers are not as good as the built-in ones but they might be better than nothing if you need to slow down a router.