Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Spice Box-drawer knobs

Posts

Spice Box-drawer knobs

#1

Spice Box-drawer knobs

Bill Tindall, E.Tn.




This knob is hardly Period Correct but I like the looks of Blackwood on walnut. It turns like plastic. There is no grain and it is hard and brittle. I love turning it. Add some wax and it shines brightly.

Shown is but one arrangement for making the knobs. I had some scraps and I mounted them any way I could to get a knob out of the piece. I turned 25 and picked the best 18, then divided them into two groups of 9 for best match for each box.

The neutral background behind the lathe enabled me to see the profile better as it was developed. The knob came out best when I could do the inny and outy profiles in one swoop.



The lathe capacity was not challenged by this need. Yes, it is two Powermatics welded together. The other end is some 11' down there. It is a long story how it came to be here.

Re: Spice Box-drawer knobs

#2

Bart Goldberg

Re: Spice Box-drawer knobs

Bart Goldberg

That is one huge Lathe! I have a buddy that has an old Oliver Lathe that is about that big.

Re: Spice Box-drawer knobs

#3

Re: Spice Box-drawer knobs

Richard McComas

Nice, but I think you need a bigger lathe for those knobs. :)

Re: Spice Box-drawer knobs

#4

Those are beauties......Next time.....

Barry Irby

I mount small pieces by sanding (on a belt sander) a really crude Morse taper on the block of wood and driving it directly into the shaft of the lathe. I have turned dozens of small knobs and "Hangers" for ornaments that way. Icicles for ornaments too. You can initially support them with the tail stock and then back it away for the final swoop and polish. I also use a homemade wooden face plate for even smaller pieces. Glue he block on with CA, turn it and part it off.

Doesn't look like you need any help, but some of those pieces are small and precious.