Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Spice Box- adding the berries

Posts

Spice Box- adding the berries

#1

Spice Box- adding the berries

Bill Tindall, E.Tn.



The plugs that will become berries are cut with the Lee Valley 6 mm taper plug cutter. This cutter is not ideal for the task. For a short plug, the plug diameter is significantly greater that the hole made by a 6 mm bit. I am having to chamfer the leading edge of the plug and drive it in.




After an array of plugs are drilled the plugs are sawed off with a band saw. I found it best to tape them. Without the constraint of the tape they fly all about the shop as they are released from the stock.


I made a template to mark the centers for the berry holes. Shown is a pin locating the hole center for the pattern of three berries. I don't try hard to exactly center the brad point drill in this locating hole. The result is some variation in berry spacing which can look better if not overdone.

Traditionally the berries were holly and cedar. I think the harder cherry works better.

Re: Spice Box- adding the berries

#2

Looking good.

Gary Smyth

Did I miss earlier photos of the tool and set up for the hex "star" holly inlay? I was waiting to discover the cutting of the holly, the tool(s) used to do the cut and the scratch tool used to prevent going outside the line against the cross grain, and how deep the cut. Were the radii all situated withiin the pattern to avoid pin holes in the field? Did I miss those steps?

Re: Spice Box- adding the berries

#3

some answers

Bill Tindall, E.Tn.

Buying the Latta DVD on string inlay will answer many questions. I, by in large, do what he does.

Did I miss earlier photos of the tool and set up for the hex "star" holly inlay? Yes. Tools are shown in Pictures 1 and 2 in the July 12 post.

and how deep the cut. about 3/32" I watch the teeth of the cutter and when they are buried I am deep enough. With experience one can feel the right depth. Which......is why there has become rapid progress on this project. Once in the "groove" , so to speak, it is best to press on while one more or less knows what one is doing.

Were the radii all situated withiin the pattern to avoid pin holes in the field? No. I don't worry about pin holes in the result. They are part of making this decoration. As such they are not to be ashamed of, hidden or otherwise avoided. That is all a modern notion applied to a 1720 process. They are not visible from a typical viewing distance and therefore do not detract from the appearance. It might be desirable for someone further scrutinizing the result to discover the pin holes and in turn speculate how the pattern was created.