Outdoor Plastic
don stephan
A recently built wheelchair ramp is exactly what my friend wanted, with one issue. The surface is 3/4" two sided MDO plywood supported by a treated 2x frame, resting on a brick step and sidewalk.
It was felt that tapering the plywood down to 1/16" or so of thickness at its lower end would have led to premature breaking off, so there is a 1" "step up" or lip. This poses no problem for wheelchairs but the homeowner is concerned that elderly persons may trip on this lip. A wedge 45" long (the width of the ramp) that tapers from 1" to about 1/4" over 6" of width has been requested.
A trial wedge of oak showed that wood is going to warp when the lower side is on damp bricks and the upper side is in the sun. Aluminum is not desired due to the risk of scratching/marking the brick. Plastic would seem to be a good material, so I'm asking for suggested compositions from those with plastic experience. Nylon? Acrylic? Polycarbonate? Other? The wedge would be shaped using a custom supporting base and router sled.
Thanks in advance.



