Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Chimney removal

Posts

Chimney removal

#1

Chimney removal

Howard

Thoughts on removing a forty year old triple wall metal chimney flu starting at he top. It consists of 36 inch sections that fit into each other and then are twisted to lock into

place.

Ideally I shout be able to twist in opposite direction and remove each section but junctions and bunged up with tar etc.

A friend suggested using a sazall to cut into sections but I'm nut sure how well it will work on sheet metal especially the stainless steel inner wall.

Wondering if anyone has any ideas?

Thanks

Howard

Re: Chimney removal

#2

Re: Chimney removal

Steve Jenkins

I would start at the top and twist it and see what happens. You might get one or several sections at once. Either way just take it as it comes. Since you are taking it down I assume it is trash so you could get a metal cutting blade for your sawzall and try it. I expect it would cut.

Steve

Re: Chimney removal

#3

Re: Chimney removal

james runchey

My son and I tore out an old hotair gravity feed furnace{from the early 1900 hundreds} which had the joints wrapped with asbestos tape. Not wanted to disturb the asbestos, we cut between the joints with an angle grinder. Worked great, didn't have to disturb the asbestos at all.

Re: Chimney removal

#4

Re: Chimney removal

john Veerkamp

An oversized pipe strap will greatly ease the twisting. Some brands have a locking ring around the joint also. If so take them off first.