Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Bandsaw Blade

Posts

Bandsaw Blade

#1

Bandsaw Blade

Kelly M. Robison

Hi All, We are now having hot weather here in the Northwest; 85 degrees today. I need some suggestions for a band saw blade. I have some real nice Black Locust logs; about 18" round and 24" long. I have a good 16" HD bandsaw with 105" blade. I want to cut the logs length wise so that I can get some boards to be planed and used in a cutting board, A chain saw will waste too much wood, but not sure what type of blade to get for this type of cut. I have tried a 3/4" wide with 3 TPI and it cuts great for cross cuts but bogs down on long cuts. Any suggestions????

Thanks again,

Kelly in Port Orchard

Re: Bandsaw Blade

#2

Re: Bandsaw Blade

Lee Schierer in McKean, PA

I think you have the right blade, but Locust is one tough wood to cut with any blade. Is the wood properly dried? Have your tried your 3 TPI in a rip cut on locust and let it cut at its own speed?

Lee

Re: Bandsaw Blade

#3

Re: Bandsaw Blade

Joseph Mulherin, sr

Kelly, I might suggest you use a 2" blade carbide tipped from ww.BandsawBladesDirect.com

Cost $121.14. Would cut thru that Locust nicely, but I would suggest putting wedges in the midst of the cut to take pressure off the blade.

Re: Bandsaw Blade

#4

Re: Bandsaw Blade

Bill Tindall, E.Tn.

On my bigger than your saw I run a 1 1/2 or 1 tpi blade for cuts in thick stuff. But I don't know if you can run these blades on a 16" wheel. You may be stuck with the 3 tpi and go slow.

Personally I would be splitting the logs down the center and sawing the halves. Locust splits reliably through the center; some wood don't.

Re: Bandsaw Blade

#5

Re: Bandsaw Blade

Keith Newton

I suggest you half it with your chainsaw, then try ripping with the BS. That blade out to be fine then. If not, it probably is more and issue of motor HP, unless the blade is dull.

When you rip with the chainsaw, avoid having the bar perpendicular to the cross grain. It is much easier if the bar is more parallel to the axis of pith, or bar tip tilted ahead of the motor end.

Re: Bandsaw Blade

#6

Re: Bandsaw Blade

Kelly M. Robison

Thanks to all that helped with my problem. A lot of good suggestions. I will try a new blade and go slow. I am restricted in using a 3/4" blade; can't go any wider. I don't want to just half the logs; I want to cut them into 1-1/2" slabs to plane and use in a cutting board. It makes a nice contrast wood when you put it next to Purpleheart.

Thank again, Kelly

Re: Bandsaw Blade

#7

Re: Bandsaw Blade

Doug Reynolds

I got some locust burl which my larger Stihl with the usual chain saw blade could not handle so, I bought a different chain at the recommendation of Stihl HQ. The stuff has so much silica it played havoc with my turning tools so, I never finished the projects.