Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Clock - finish color - John in NM

Posts

Clock - finish color - John in NM

#1

Clock - finish color - John in NM

Joe in a Cleveland suburb

"John in NM" asked about the color of the finish on the clock I am working on. I took a couple quick cell phone pics that show the color pretty well.

This is what it is looking like color-wise. On my monitor here at work, these pics are a little more brown than in reality. It's close though.

I am showing the backside of the lower door (that's why I took these pics; somebody wanted to see the raised panel). When installed the raised panel is to the back.

#1


#2


The back of the case is also in the picture. I've just started to put dye on it. Needs a bit of sanding then shellac.

While the finish dries, I am also cutting mortises/installing the hinges on the doors.

I need to turn a couple knobs for the doors yet.

Closing in on completing it. Should be done by Christmas...

Re: Clock - finish color - John in NM

#2

Re: Clock - finish color - John in NM

Dick Coers

I love the color but am distracted by the white edges around the panel. Is the color gone there, or an issue with lighting in the picture? Wonderful craftsmanship on the clock!

Re: Clock - finish color - John in NM

#3

I like it!

John in NM

You've got a good eye for curly maple color :D

Did I ask yet if it's a straight tint or did you mix it?

Re: Clock - finish color - John in NM

#4

Re: I like it!

Joe in a Cleveland suburb

John,

This has been sitting in a jar unused for some time. I can't be 100% sure, but I labeled the jar "Early American Maple - TransTint". I'm pretty sure that's all it is.

I'm also pretty sure it was mixed with distilled water per the instructions on the little jar.

I ragged it on some scrap. The wife approved...