Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

plumbing stupidity

Posts

plumbing stupidity

#1

plumbing stupidity

Jerry Gibbs

Tried to re-seat a sink strainer with old plumber's putty ( the can did not have a bar code). The can promised the stuff did not dry out, so I scraped soft stuff from the bottom. After the strainer still leaked, I spent $1.49 on a new can and there is no leak. I won't bore you with my story about the old contact cement. Jerry

Re: plumbing stupidity

#2

Re: plumbing stupidity

Jerry Roberts

Hey Jerry. I went through the very same thing last weekend installing a new garbage disposal. I got the whole thing installed, turned on the water and...leaking.Took the whole thing out and determined the putty was shot in the sink plate. Had to go to box store to get some more as mine was hard as a rock. The new stuff wasn't too much better. I didn't know how to soften it. Water didn't work so I tried a little mineral spirits. I know it wasn't the correct thing to do but it worked. What a pain in the back side that day was!

Re: plumbing stupidity

#3

Re: plumbing stupidity

John McGaw

If it is the real old-school plumber's putty then I believe the corrective action is to add a bit if linseed oil and then knead it for all you're worth. If it is beyond kneading then the proper thing to do is to throw it away and start again. I find that I usually misplace my previous can of putty until after I finish the current job with a new can. I usually find the old can(s) right afterward.

Re: plumbing stupidity

#4

Kneale Brownson

Next time you open that new can of putty...

Kneale Brownson

I remove all putty I can from the container when new and put it into a small ziplock plastic bag before I return it to the container. I've had the stuff last for years AND years using that approach.

Re: plumbing stupidity

#5

Re: plumbing stupidity

Dick Coers

Modeling clay needs a little time in a very low temp oven. Might work with plumber's putty as well, but never tried it. I'm to the point where I can't find any supplies in the basement shop any more. Any project starts with a half hour search, then a trip to the store. Won't be long before all trips start with a trip to the store. It will reduce the frustration factor a LOT!

Re: plumbing stupidity

#6

Re: plumbing stupidity

Bill Turpin in WNC mountains

To be a certified plumber you have to only remember:

1. It won't flow uphill.

2, Hot is on the left, cold on the right.

3, Payday is Friday.

4. The boss is a SOB.

I know where my can of putty is, but I own 17 caulking guns!

Re: plumbing stupidity

#7

Re: plumbing stupidity

Jerry Nicholson

You left out the most important rule of all for plumbers:

Don't bite your fingernails!

Jerry