Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

New drawer making joinery *LINK*

Posts

New drawer making joinery *LINK*

#1

New drawer making  joinery *LINK*

Tom Dunlap

I read Make Magazine and found an article about a custom sawblade and dado setup that a guy made. In the end it leaves a fold-up joint.

Easier to take a few minutes to watch his video than for me to attempt an explanation.


Drawer joinery

Re: New drawer making joinery *LINK*

#2

Re: New drawer making  joinery

TomD

That is an interesting idea. In his setting, with a few finishing nails, those drawers would see a lot of service, with glue only and given the nature of ply gluing, they are not going to last. I have seen dovetail front and finger joint back drawers come apart and they were less loaded, and more strongly built than those are.

I think he has something there though. The fact you can quickly make boxes that have folded edges is an usually aesthetic.

Re: New drawer making joinery *LINK*

#3

Terrific Innovation


Re: New drawer making joinery *LINK*

#4

Re: New drawer making  joinery

William Duffield

Where do you get it sharpened? Does the geometry still work after it's sharpened a couple of times? Doesn't it need to be precisely matched with the dado stack and that fit maintained through every sharpening?

And then, there's the problem with variable plywood thickness.

Re: New drawer making joinery *LINK*

#5

Re: New drawer making  joinery

Richard McComas

Isn't that just a different profile of an old concept of miter folding? Miter folding has been around a long time but usually uses a V grove.

Re: New drawer making joinery *LINK*

#6

Re: New drawer making  joinery

Lee Schierer in McKean, PA

I would like to see how it performs in solid wood rather than plywood with the slots being cut for a plywood bottom like he did for the small boxes.

I really liked his sled for crosscutting the long piece of plywood.

His box test would have been better if he had made a finger or dovetail jointed drawer from the same material and subjected it to the same testing.

Lee

Re: New drawer making joinery *LINK*

#7

But

CJ in MPLS

carbide never needs to be sharpened does it? ;)

I would bet that you might be able to get by with one or two sharpenings, but then most of these would be sold to punters that wouldn't use them in the first place, let alone sharpen them. Hardcore woodworkers that take care of their tools are, I believe, in a bit of a minority in the marketplace.

CJ