Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Cleaning Band Saw Tires

Posts

Cleaning Band Saw Tires

#1

Cleaning Band Saw Tires

don stephan

Replacing with new might be an ideal solution, but not at this time. Have bits of sawdust stuck to the band saw tires, probably in part from cutting green bowl blanks. Have a brush angled as instructed in a band saw book, but still have accumulation. Tires are black, probably original to the Minimax saw. I'd like to clean the accumulation without damaging the tires if possible. Any suggestions?

Re: Cleaning Band Saw Tires

#2

Re: Cleaning Band Saw Tires

BrianMonumentCO

Get a toothbrush, you can use your own if you want or buy a new one.......

Get a FIRM not a soft. Carefully spin the blade while holding the toothbrush bristle to the tires.

Continue until the tire is clear of debris.

There are several sets of tires so above and below the table at least.

I once saw an attachment that held a brush on the tire permanently.

Cannot remember where I saw it .... May have been shop made.

Good idea though...... I would use a medium as opposed to the firm for that purpose.

And would clean the brush off occasionally.

Just my 2 cents worth. Other opinions may be worth more......Or they may just charge more.

Re: Cleaning Band Saw Tires

#3

takes more than a brush on bottom wheel

Dick Coers

I use a card scraper after cutting a lot of bowl blanks or wet wood. The dust is like it is welded to the rubber, so I rest a card scraper against the rubber, and spin the wheel by hand. Then brass brush after that. Brush alone is often okay for the top tire. I've done this often, over many years, with no ill effect to the tire.

Re: Cleaning Band Saw Tires

#4

What Dick said works for me too.


Re: Cleaning Band Saw Tires

#5

I was assuming dry wood.