Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Veneering Question

Posts

Veneering Question

#1

Veneering Question

Howard

After gluing redwood veneer to a small table top with Unibond 800 I found a area about one by two inches where the glue did not hold. It bubbled up about 3/16 inches. In the past when I faced this problem I would make a slit in the veneer, pry it open, inject glue and press the bubble down. In this case the veneer was to stiff to pry it open after making a slit.

I came up with a Rube Goldberg solution. It took a number 11 scapel and poked about 150 tiny indentations in the veneer, painted the area with a 50 percent water dilution of Titebond three, and pressed the bubble flat for 24 hours. Sanded after removing the clamp and bubble is gone and no evidence of repair.

Finished with BLO. And shellac.

Am I fooling myself in thinking that the repair will hold and that the bubble will reappear?

Thanks

Howard

Re: Veneering Question

#2

Ellis Walentine

Should work

Ellis Walentine

This is a variation on a time-honored method for gluing down bubbled veneer. My personal method involves using a specially ground X-acto knife and slicing into the bubble in the direction of the grain, with the knife held at about a 45º angle to the surface. I work the glue (full-strength) into the slit using a finger to squeegee the glue. The angled cut assures that, when re-glued, there will be no evidence of a knife mark.

Ellis

Re: Veneering Question

#3

Re: Should work

Howard

Thanks for the vote of confidence. My concern is that the pinpricks I made did not go all the way thru the veneer so the compressed area was not glued to the substrate.

I think bubble is just compressed flat by the little bit of glue going into the pinpricks.

Howard

Re: Veneering Question

#4

Re: Should work

Dick Coers

I would worry about the Titebond sticking to the Unibond residue in the long term.

Re: Veneering Question

#5

Parallax is a trick I've used,

Keith Newton

To drill a hole from the back side, if there is no way to measure from two different sides. Then with a small drill, with the depth marked by tape, I drill up almost to the surface from the back side. You would be surprised how easy it is to place your finger right on top of where the drill will come up through the opposite surface while looking down both sides of a panel, from two different perspectives. Then as you slowly drill through the substrate, you can feel the drill when it touches the back of the blister.

You can then use a syringe to inject your adhesive of choice in from the back. If you have pricked around the perimeter to allow air to escape from the front, then you can fill the void, and press it down with a caul faced with packing tape.

I'm kinda partial to epoxy for this most of the time, especially if it is out in the middle of something hard to clamp.

If you have never tried this, you will be surprised at how easy you can hit your mark every time, with very little practice.

Re: Veneering Question

#6

Re: Veneering Question

Brian Roberts

How was it clamped initially?

Did the area not get glue coverage?

Is that glue heat reactive? Could it be ironed down......like PVA glues can be?