Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Question on JB Weld

Posts

Question on JB Weld

#1

Question on JB Weld

Barry Irby

A friend has a little gas powered power washer. The gas tank rests against a metal rib and has vibrated enough to wear through the tank. A new gas tank is $36 plus shipping. This is a small (maybe a quart) metal tank. If we clean the area and sand it and patch it with JB Weld, will that work? Will gasoline destroy the JB Weld? We have filed the rib down and covered it with rubber.

Re: Question on JB Weld

#2

Auto Parts Store

robbcarr

Auto parts store will have a 2-part epoxy putty for gas tank repair.

Re: Question on JB Weld

#3

Re: Question on JB Weld

Bob Entwisle in NJ

Hi Barry,

I'm pretty sure that the JB weld will do the job for you, as long as everything is clean to bare metal etc.

I used JB weld to seal a machined aluminum mounting flange to a new flange-less Harley carburetor to adapt it to my old Harley and it's been fine for the past 6-7 years or so.

Another alternative would be to solder a patch onto the tank, (I know it's obvious, but make SURE all the gas is gone and the tank is rinsed clean etc.:))

Bob in NJ

Re: Question on JB Weld

#4

Many tanks repaired...and a tip

Tom Dunlap

I've fixed many plastic and metal gas tanks with JB Weld.

Here's a tip that I got when I did my first repair back in about '77.

Drill a few holes around the edges of the patch. Then moosh the epoxy in so that you're sure that some gets pushed through the holes. The epoxy will mushroom on the back side like a pop rivet. This gives more bite to the repair instead of just being surface application.

Two or three thin layers each getting a bit larger in diameter works well if the repair is large.

Tom

Re: Question on JB Weld

#5

Thanks, The patch is curing....

Barry Irby

I read the package and it did not say not to use it around gasoline, but then it occurred to me that alcohol will clean up epoxy nicely and I got to wondering about gas.

Now I have to figure a way to attach the rubber cushion better or it will just vibrate away. Wish I had thought to set a little metal shield on top of the the JB Weld.