Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Jet Lathe Speed Control

Posts

Jet Lathe Speed Control

#1

Jet Lathe Speed Control

Jack Prescott

I have a Jet Model JML-1014I. This model does not have variable speed control except by shifting the belts on the pulleys. I want to know if it would be acceptable to vary the speed using a 110 volt / 15 amp router speed controller that I have without damaging the motor?? Thanks

Re: Jet Lathe Speed Control

#2

Re: Jet Lathe Speed Control

Stuart Johnson

You would be better off asking your question on the turning board but I'm pretty sure it won't work.

Re: Jet Lathe Speed Control

#3

router variable speed control won't work

Dick Coers

I've also read some poor reviews of the PSI replacement kit. Best to convert your lathe to a dedicated buffing machine and buy a new one if you want the variable speed.

Re: Jet Lathe Speed Control

#4

Re: Jet Lathe Speed Control

John McGaw

They don't seem to say what sort of motor is on the lathe but it appears to be an straight-up single phase induction motor. That pretty much shoot down any sort of easy speed control. On a lathe that small I'd simply adjust my technique to turn with the six speeds that are available. Failing that, I suppose you could go searching for a VS DC motor that will fit (three-phase motors which are needed for variable-frequency typically being pretty sizable) and go for it after choking on the cost. Realistically it would be just as easy to find a different lathe and sell this one.

Re: Jet Lathe Speed Control

#5

Re: Jet Lathe Speed Control

Jack Prescott

Thanks to all! Jet says do not do it = it will burn up the motor in a short while!