Solid panel questions
Joe in a Cleveland suburb
I am trying to decide how I want to make the panel for my wall clock's bottom door (top door is glass).
I have the rails and stiles cut, mortised/tenoned, and ready to go (glue up). Just need to make a panel to fit in the grooves. The panel will be maple. Not quarter sawn. The grooves in the frame are ~3/16" wide X 5/16" deep. The frame will accept a panel up to 17-7/8' X 8". The frame is made from 1/2" thick stock. All curly maple.
First question:
How much smaller should I make the panel to allow for movement in its width (the grooves are 5/16" deep)?
More questions:
I have numerous pieces of figured maple scraps, cut-offs, and so on to make the panel.
Should I take a piece and rip it down the middle and do book matched? I'll end up with a panel that has grain going in two directions, right? Not sure I'd like the look of that. I would wind up with two pieces that are over 4", glue them up to end up with one panel.
I'm thinking of making the panel thicker than 3/16" and using a plane to bring the edges down closer to 3/16 to fit the grooves. Thinking I would end up with a stronger/flatter panel that way. Kinda like a raised panel with the thicker side to the inside of the clock.
I could do a regular raised panel also with the raised field to the inside.
I guess I have lots of options. Just looking for some input/further ideas.
My biggest question is how much movement to allow for in the width of the panel.
Thanks a ton for any input.
Joe



