Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Freud Forstner bits

Posts

Freud Forstner bits

#1

Freud Forstner bits

Jack Putnam

I am in the process of buying a set of Freud Forstner bits PB-100 but then I came upon a question what is the difference between forstner bits with serrated edges and without serrated edges. I can't seem to find an answer on the internet. I would like to find out before I buy a set. Does it really make a difference in cutting the wood. Right now I have a set made in China and they suck. Thanks for any help.

Re: Freud Forstner bits

#2

Re: Freud Forstner bits

John McGaw

I was always taught that the saw-edged bits minimized the heating of the rim which is often a problem with 'regular' Forstner bits. In real-world situations I suspect that there is little difference between them. FWIW, I have Freud Forstner-pattern bits ranging from 1/4" to 1-3/4" and have never had any trouble with them -- only a few of them have needed touching up with a diamond paddle in over a decade of use.

Re: Freud Forstner bits

#3

Re: Freud Forstner bits

Bill Turpin in WNC mountains

Freuds are good but Colt maxi bits are better. Colts are EXPERNSIVE, but use one, you will never go back, you will quickly forget the price!

Re: Freud Forstner bits

#4

Re: Freud Forstner bits

Joseph Mulherin, sr

Try using a set from Harbor Freight. Had my set for about three years and still sharp and cuts good.

Re: Freud Forstner bits

#5

Re: Freud Forstner bits

Bill Turpin in WNC mountains

Try drilling end grain tropical hardwoods on a lathe and you will throw your HF bits away. We no longer have our Freuds either!

Re: Freud Forstner bits

#6

Re: Freud Forstner bits

Joseph Mulherin, sr

I don't do that type of woodworking. My lathe usage is making spindles for cribs, table legs tapered,

and things like that. Using my lathe duplicator I can make multiples of almost anything of the original design......not drilling on hardwood end grains.

Re: Freud Forstner bits

#7

Re: Multi-Spur Forstner bits

William Duffield

Explanation is here:

http://www.woodmagazine.com/woodworking-tips/techniques/drilling-boring/drilling-and-boring-tools/?page=3

I haven't used the Freud bits, but I have used the Famag Bor-Max bits (Also German), and am very pleased with their performance. Colt bits are also high quality.

The technique for preserving your Forstner bits, either the cheap Chinese or good quality German, is to keep from overheating them. (This is very, very difficult to do if you are using them in a lathe.) Plunge quickly, and immediately retract them completely from the stock. Stop plunging immediately and retract if they clog and stop ejecting chips. Don't try to drill a deep hole all at once. When you've retracted them, let them cool off, while continuing to spin.

If you follow these procedures, there's no reason to spend a fortune on a complete set of German bits. When I've finally worn out one of my Chinese bits, I replace it with a Famag. I've drilled hundreds of holes in rock maple with one 3/4" Bor-Max bit, and recently also replaced my 5/8" Chinese bit.