Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Identifying sapwood in freshly milled cherry

Posts

Identifying sapwood in freshly milled cherry

#1

Identifying sapwood in freshly milled cherry

Jim in N. Va

In the rough lumber, the sapwood was very obvious. Yesterday, I rough cut the boards over size, cutting out much but not all of the sap, and planed them. I had planned to cut out the rest when I ripped the boards to final size.

But now I cannot distinguish the sapwood. If I expose the boards to sun light for a while the distinction will be obvious. However, I would like to continue working today and I need to make sure there is no sapwood left. Any tricks to make the sapwood quickly pop out to these aging eyes? I tried wiping on rubbing alcohol and that did not help.

Thanks,

Jim

Re: Identifying sapwood in freshly milled cherry

#2

Re: night and day obvious

Bill Tindall

If you can"t see it it's not there. the sapwood will be white, yellow when fresh sawed

Re: Identifying sapwood in freshly milled cherry

#3

Try wiping with ammonia...

John in NM

Do it on a scrap first, I'm not certain how pronounced the effect is or how deeply it penetrates. It should mimic the effect of sunlight - does with mahogany.

I remember one period working for a shop where all we got was the crummiest cherry you've ever seen - grain was pretty coarse and the wood was so pale you couldn't hardly spot the sapwood. Boss wasn't happy with the stuff, but I don't think he did much about it.

Re: Identifying sapwood in freshly milled cherry

#4

Re: Identifying sapwood in freshly milled cherry

Tony - Memphis

I know what you mean. It is hard to tell the difference sometimes. I built an easel for my wife and didn't notice that one board had some sap wood in it. Turns out it is in the very front and of course I notice it every time I walk in her studio. The rest of the easel is aging nicely but thaty one piece jumps out at me. Doesn't bother her though. Maybe, eventually, it will get covered with paint splatters! If you figure out a good trick, let us know.

Tony - trying to avoid sapwood in a cherry laptop stand I'm building right now.

Re: Identifying sapwood in freshly milled cherry

#5

Re: Try wiping with ammonia...

Jim in N. Va

Thanks, I will try the ammonia and see what happens. I know Bill thinks it is obvious...and I am sure to him it would be. Unfortunately the milled boards are pale and it is not so obvious to me.