Electronic controls? Am I the only one?????
Barry Irby
There is a long post (or group of posts) about the inverters for lathes on the Turning forum. It seems they are out dated and out of production after a few years.
Yesterday I watched a segment of This Old House and they were touting a HVAC system with all sorts of dampers and a digital thermostat. As a Home Inspector in a very conservative part of the country I have seen about a half a dozen systems with zoning dampers. None of them was set up and working properly.
I was in the market for a car and some of them were "Powered by Microsoft". My son, who builds computers and is far more into it than I have ever been, snorted and said, "Microsoft never supports anything for more than ten years."
I admit I am turning into an old Fuddy Duddy, but am I the only one that sees these things and is skeptical? I thought a lathe was supposed to last a lifetime, or more. Your ten year old or his grand dad should be able to operate your HVAC system. And I tend to drive my cars a long time, with ten years being the first step. What happened to the KISS principle? Durability?

. You are absolutely correct, today's cars are so much more reliable and maintenance free that there is absolutely no comparison. Back then, any car still running at over 100K miles was held in awe. Most cars that hit 70K were burning oil and likely in need of a valve job.



