Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

type of plywood

Posts

type of plywood

#1

type of plywood

Jack Putnam

I am in the process of building a fly rod cabinet and I was wondering what type of plywood I could use that would take stain real well. The rest of the cabinet will be in pine. I was going to use birch plywood but I heard that when you apply stain to birch that it will be uneven. I don't want to get to expensive.

Re: type of plywood

#2

Clint Searl

Oak


Re: type of plywood

#3

choices are limited

Bill Tindall, E.Tn.

Cheap means you will be using birch, fir, pine or oak. Oak will be easiest to make look good, but pine trim will look awful with oak. Use oak trim if you are using oak plywood.

Or use pine trim and plywood. People here have a preferred stuff to put on before the stain to make it go on even. As about "stain blotch prevention".

Re: type of plywood

#4

Re: type of plywood

Keith Newton

Why not just use a cabinet grade knotty pine plywood. You may not be able to get it at the big box stores, but the cabinet suppliers probably have it.

Re: type of plywood

#5

If you like Birch

Gary Smyth

Why not use birch ply and solid Birch for trim and rod holders? You might need less than you think. At least price out the solid Birch. In Western PA the price is about the same as Oak. It is heavy, much harder than pine and can splinter but the cost should not be too great and workability with tools is good (you may have to scrape burn marks though). Yes, stain can go on unevenly without pre treating. Dyed or undyed dewaxed shellac will apply easily, show grain, and get better with each coat. Test a scrap piece and see if it will work for you. Birch ply often has flame pattern. NOT my work, and not plywood, but Birch can look great, it is tough -- and it ages well. Several coats of shellac for a test shouldn't take more the half a day. I'd apply finish before assembly even if you have to scrape some away to fit in mortises/rabbets for final glue up.

Re: type of plywood

#6

looks like it shoud be in the Gallery

Bill Tindall, E.Tn.

Handsome piece, but a novice is not going to be able to work and finish birch like you did.

Re: type of plywood

#7

Not my work, as stated. Wish it was