Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

gun smithing woodworking question

Posts

gun smithing woodworking question

#1

gun smithing woodworking question

Bill Tindall, E.Tn.

The factory finish on the stock of an inherited Ithaca Model 37 pump shotgun is largely gone. I have been hunting with it and realize that I need to refinish it for protection(I will simply oil it as this approach lasts best for me). How do I get the stock and forearm off.

Not as dumb a question as it might seem. Many years ago I took the stock off a Winchester double except I removed the wrong screw. Things went sprong! When I retrieved the put back together mechanism the smith lectured me to NEVER remove that screw again. Well, I don't know what screws are holding the stock on and I don't want to risk removing the wrong screw again.

Re: gun smithing woodworking question

#2

Re: gun smithing woodworking question

Larry Clinton At Frankfort, (Central) Indiana

Not difficult Bill, to remove the stock, you remove the butt plate and reach into the exposed round hole with a LONG straight bit screwdriver, as I recall the screw is pretty big so a wide blade driver will fit. The removal of the front fore end is a little more involved, there is a release "pin" exposed in the bottom of the loading area that releases the entire fore end, then you unscrew the nut at the end of the fore end stock. Can't remember if you can just unscrew the fore end nut and remove it without releasing the mechanism.

A U-tube video shows the method fairly well: https://www.youtube.com/watch?v=WLqW-Zbv51I

Re: gun smithing woodworking question

#3

Here's the great thing about the internet.... *LINK*

John in NM

I have no idea how to remove that stock, but there is always a youtube video for any gunsmithing task you want to know about. There is probably one for putting the mainspring & screw back together when you mistake it for a stock screw :D

The only downside to these videos is the horrible music they usually put on them. You wouldn't think one on a vintage shotgun would open with some kind of heavy metal, but I'm afraid this one does.

Of course, this one isn't so bad as one I watched on drawboring yesterday. Horrible! (the music that is, video was ok other than all the hemming and hawing)


https://www.youtube.com/watch?v=WLqW-Zbv51I

Re: gun smithing woodworking question

#4

question and thank you all for leads

Bill Tindall, E.Tn.

what sort of Whuss works on a shotgun wearing latex gloves?

Anyway, thanks for the tip and I can carry on from here.

BTW, mine is way older than the one in the video, before 1950.