OK, so I've decided on M&T joints for my son's Bandini bench (rather than finger-jointed box) but must now decide on how I will join the solid wood (4" wide by 1" thick) seat trim to the top edge of the 3/4 ply. I could just glue it, but this joint will have to take weight and it must be off-set as shown. So here are what I figure to be my choices
A is a spline joint.
B is a butt joint with a gusset strip.
C is a 3/8" dado into the solid.
Opinions?
Caveat: No iron in the formula. The only metal in this piece will be the piano hinges for the seat/lids