Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

"Emtag" removal

Posts

"Emtag" removal

#1

"Emtag" removal

Randy Stukenberg

It seems like about every power tool I buy anymore has that plastic "Emtag" that slides up and down the cord and usually gets in the way when I wind it up. Does it serve any useful purpose, or is it just a store security measure. It says "Do not Remove" on it. Is it kinda like the tag on your mattress...?

Re: "Emtag" removal

#2

Good reason to buy cordless  lol


Re: "Emtag" removal

#3

Re: "Emtag" removal

waroland

If you read the fine print is probably says not to remove except by consumer.

Re: "Emtag" removal

#4

Plastic?

John in NM

If it's a plastic loop around the cord a pair of heavy side cutters should do it.

I take all that junk off, though I haven't bought a corded tool in so long I'm not familiar with this particular tag.

Re: "Emtag" removal

#5

Probably a toroid for EMC

Virgil Johnson

It is probably a toroid that is on the tool to reduce EMC frequency bandwidth. To reduce interference with radio or tv reception. I'm not highly schooled on the matter just know that we have to put them on cables of devices we manufacture in the printer industry.

Re: "Emtag" removal

#6

Re: Probably a toroid for EMC

Richard McComas

It's a security device. Give it a good whack with a hammer and put it in the trash.

Re: "Emtag" removal

#7

Yep. Security tag

Virgil Johnson

You are correct. I glanced at the one on my dremel when I bought it and assumed it was a quick cheap way to apply a toroid. Its been on there for a decade so I guess I'll leave it be.