Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Barracuda CSC2000C Lathe Chuck

Posts

Barracuda CSC2000C Lathe Chuck

#1

Barracuda CSC2000C Lathe Chuck

Bill Marr

Fellow Woodworkers,

Recently I inherited an old Montgomery Wards lathe. I plan on learning to use it and make small projects. Thinking of buying a Chuck for it. The arbor is 3/4 x 16 TPI. Would the Barracuda CSC000 be suitable for this machine and my needs? Is there any history about it's quality? Thanks for your help.

Bill

Re: Barracuda CSC2000C Lathe Chuck

#2

Re: Barracuda CSC2000C Lathe Chuck

Don Orr

You might get more feedback on the Turning Forum but my response is that chuck is a reasonable piece of equipment especially for a beginner to learn with.

Are there better chucks out there-sure but this one will get you off to a good start.

Go check out the Turning Forum and have some fun.

Re: Barracuda CSC2000C Lathe Chuck

#3

Re: Barracuda CSC2000C Lathe Chuck

Bill Phoenix, MD

Thanks. I put it on the Turning site as you suggested. I appreciate your input.