Walnut color and how it changes with time
Bill Tindall, E.Tn.

The walnut board on the top was sawed about 1975, then air dried, planed and stored ever since in a single board-wide stack in a dimly illuminated loft . Dim light fell on the edge of the stack that this board was within, but not its surface.(it was in the middle of this stack , not on top)
The board on the bottom was more recently sawed, it may or may not have been kiln dried(doesn't matter to color), it definitely was not steamed(matters a lot to initial color) and it was planed a few minutes before the picture was taken. Hence, its surface has only been exposed to light for a short time.
The bottom board shows the fleeting color typical of a freshly exposed walnut surface. Without some treatment to exclude light and oxygen this color will not persist.
The top board shows what happens to the purplish color of freshly exposed walnut after exposure to light and oxygen. Even in subdued light the color changes from purplish to yellow-brown. One can clearly see the change in color and bleaching from the edge of this board that was exposed to the dim light to the center which was covered by the board above and below it that largely excluded light, but not oxygen.
The lesson here is that walnut color is not lightfast. Finish may alter the bleaching process and the eventual color the walnut arrives at by slowing the effects of light on the wood coupled with the coloring of the finish by light and oxygen.






