OT - Calling All Clogged Toilet Gurus
Joe Pack
3 year old Gerber toilet worked fine...would almost suck you down when flushed. 5 days ago I flushed and the toilet almost overflowed. I let it slowly drain down and flushed again, with the same result. So, out comes the plunger and I plunge/flush several times, still essentially clogged, but would slowly drain down to normal. After 10 minutes, I walked away, figuring I'll go find my drain snake and go to work after dinner.
One last time before going out for the drain snake, I flushed again...and the toilet worked just like normal. I flushed several times, and each time the toilet worked just like it always did. Figuring something inhumanly large had finally dissolved and passed, I walked away glad that I didn't have to do anything.
3 nights ago, the gremlin came back. After my 3 a.m. "old man's wake up call," I flushed and everything worked as usual. 4 hours later, though, the toilet gremlin struck...the water simply filled the bowl and swirled, very slowly going down. Since then, the toilet will not flush properly. The tank will empty, the bowl will fill and the water will slowly go down. But now the water in the bowl goes almost all the way down instead of the 3-4 inches normally in the bowl.
Laws of physics say that the water level standing in the bowl should be equal to the water level in the built-in S trap in the toilet, but mine is a good 3" below where it was before the problem. It seems that the water level in the bowl continues to go down long after the flush has been completed, almost completely draining the bowl.
The tank fills properly. The bowl fill spout is working properly. In other words, the "innards" of the toilet are fine.
For what it's worth, there are three toilets on this line. If you visualize a line of three toilets, the ones on either end of the line work just fine. It is the one in the middle that has the problem. What gets me is that the toilet worked fine, then would not flush, then worked fine for a couple of days more, then again will not flush. A clue, I think, is that the water in the bowl of the problematic toilet seems to be siphoning down on it's own...no evident cause for this to happen.
I imagine I will probably have to remove the toilet to get to the problem, but I'm hoping some of the self-professed toilet gurus here might have a thought...or magic spell...to help before I go this route. All ideas and smart-ass comments are more than welcome...I could use the help and/or the laughs!




