Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Air impact wrenches

Posts

Air impact wrenches

#1

Air impact wrenches

Terry Alexander

I have a couple of air impact wrenches that have sat for years as they came with my compressor.

I have a 48" dual blade mower that I always dread swapping blades because I invariably need a 3/4" socket with a 2' breaker bar to get the nuts off. Just on a whim I tried the air impact wrench and they came off easy as pie. However, I was afraid to put them back on with the air impact driver because I didn't know how tight they would go or I might break/strip something.

Having said/typed all of that, when the mfg says to put bolts on to 300 lbs of torque, how can I measure that with an air impact driver.

Alas, I'm a woodworker (not a very good one) and I'm sure not a mechanic.

Any and all advice would be appreciated.

Terry Alexander in West Texas

Re: Air impact wrenches

#2

Jason Roehl in Lafayette, IN

Re: Air impact wrenches

Jason Roehl in Lafayette, IN

There are attachments for air impact wrenches called something like Torque Sticks. I believe they are extensions that come in different colors that each correspond to a torque rating.

As for actually measuring the torque, I suspect there are probably tools out there that are geared for industry, but prohibitively expensive for home shops and even the typical mechanic, considering even a good (manual) torque wrench that goes to 150 ft-lbs can be 3 or 4 Franklins.

Jason

Re: Air impact wrenches

#3

Re: Air impact wrenches

iew

Be sure to disconnect spark plug wire!

Re: Air impact wrenches

#4

Jack Guzman from Maine

Re: Air impact wrenches

Jack Guzman from Maine

300foot lbs is alot of torque.Or was that inch pounds? If it was foot I wouldn't worry about getting it too tight.Just let the impact hammer a couple times. if it is inch pounds I would hand tighten with a wrench til snug.---Jack

Re: Air impact wrenches

#5

Bart Goldberg

Re: Air impact wrenches

Bart Goldberg

I use an electric impact wrench for doing just the same thing. I never worry about the amount of torque used to put the blades back on - just make sure they are tight. The blades rotate in a direction to keep the blades from loosening and rotating off.

Bart

Re: Air impact wrenches

#6

Comment

Bill Tindall, E.Tn.

"2' breaker bar to get the nuts off" That is because the threads are arranged to tighten in use and if the blade hits a stump they will tighten even more. The blade nuts only need to be tightened enough that the blade does not slip. I would mainly be concerned that the air wrench would over tighten. You can be sure that the nuts will be tighter when you need to change blades than when you installed them.

Your wrench will likely have torque settings on it somewhere, if only low, medium and high. For installation use the smallest setting that prevents slipping of blade.