Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

OT electronics, testing a clothes iron

Posts

OT electronics, testing a clothes iron

#1

OT electronics, testing a clothes iron

TomD

Just as with the arcane expensive stuff we sometimes covet, other activities have their insanely expensive and unavailable tools. In tailoring it is a heavy dry iron. They can cost 500-1000, and not far off that when they are made in India.

I found two quite old ones that are American made, but I am concerned about whether they will work, and how to go about testing them before just plugging them in. There are woodworking equivalents to this like side benders for guitars and violins. The irons have cord, and I guess probably one of thos espiral wire elements. One of them has a rheostat with several positions, and the other has just one heat setting.

I was wondering whether it would serve any purpose to continuity test all the settings. Or if not, what to do.

If some of the parts are burnt out, any idea where to get replacement parts for heaters?

Also, any cheap, but reliable (I think there actually are, but I forget what hobby I read about them), heat controllers that would be available to run either the single heat unit, or the variable, since a heat controller would probably be better than the mechanical setting.

Here is a picture of what a modern one looks like, this one also has steam. Typically they weight 12 pounds.


http://danor-engineering.co.uk/goose-iron/

Re: OT electronics, testing a clothes iron

#2

Re: OT electronics, testing a clothes iron

del schisler

i guess if you have access to a ohm meter and test for continuity turning the off and on and see if their is continuity, if so element apears to be good, now with out a watt meter so you can plug unit in and see what the amprage is, that it is a guess a crap shoot about that, but it should heat up ? about part's ? if unit works than no parts needed , but about the element wire , their are different size and the length for the wattage or currant draw , it will say on the lable is and model number, i wouldn't worry much yet, that stuff is avaible , may have to do search for that , good luck on them

Re: OT electronics, testing a clothes iron

#3

Re: OT electronics, testing a clothes iron

Bill Howatt

You could probably dispense with the rheostat control if it is broken and power the iron through an electronic variable-speed control box such as available for routers. There are light dimmers that would work but they are usually limited to about 400W.

Nichrome heater wire is available so repairs aren't impossible. A bigger problem might be fixing any broken heater supports since these are usually ceramic and may be a custom shape.

Bill

Re: OT electronics, testing a clothes iron

#4

Re: OT electronics, testing a clothes iron

TomD

Thanks for the ideas, these things are so heavy one wonders if they even use standard elements maybe they use something solid like what is in a kettle. That would be nice if it contributed to longevity.

Any idea what to ask for in cord. The irons look fine, the cords need upgrading, but they need to be appropriate to heat, or long use.