Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

OT - How to re-grout a shower floor

Posts

OT - How to re-grout a shower floor

#1

OT - How  to re-grout a shower floor

Joe Pack

My sweetheart wanted the dirty, darkened grout removed from our shower floor and replaced with a new, clean grout "No problem," says I.

Then I considered the looks of the tiled floor...scratched, dingy, not pleasing...and decided to just chip up the 3x4 area and put in new tile...it would look a whole lot better.

Then, as the tile as coming off, I found a small damp spot in a corner. Digging deeper, I found a larger damp spot that was actually spreading up the wall a bit. So, off comes the bottom wall tile to investigate. Lo and behold, a wet wall. So, off comes a section of the wall (and overlying tile) which allowed me to find the source of the dampness....some idiot had years ago driven a #6 nail into the bottom 1/2 of the wash basin drain line where it had eventually rusted to the point of letting water seep out. This must have taken some effort, since the idiot actually drove the nail through a steel cover on the stud that was installed to keep just such a thing from happening!

So, off comes a bit more wall and tile to repair the plumbing. Of course, the tile could not be matched, so....off comes the tile and old mortar and old cement board all the way down to the studs. And would look really weird to have one wall a different color, especially since I chipped some corner tile when my hammer and cold chisel got loose somehow.

So, off comes the rest of the tile and wall board, all the way down to the studs. And while I'm at it, I always did want a vent fan and brighter light in the shower ceiling. So.... Now we are at the "tear it all out" stage, including new hardware, including replacing the door that had the finish scratched and worn off from use (and poor initial quality).

Now we had to pick out tile. Not just any tile, but THAT tile! You know, the one you can't afford, so you try to find one almost like it that won't cost 3 months salary. And then the trim, which costs three times more than the tile!!

As long as we are at it, I'm going to make sure the shower does not leak, so a new floor and wall membrane go in; do it once, do it right. And finally the tile starts going in and up. But now the old shower head/hardware looks sort of dingy....off to find a decent set-up that won't leak or break or fall apart the first month, but does not cost more than a new car. Found it, but a bit more $$ than I had planned. What the heck, you only live once, I'm old and I deserve a good, relaxing shower at least once a week.

So tile is almost up, shower head/hardware/door are ordered and in, and I have spent my Christmas, birthday, vacation and summer fishing money...still working on spending my sons' inheritance on this shower project. Oh..."we" (read that as "she") is thinking maybe the rest of the bathroom might..........

My replacement knees and replacement shoulder are starting to let me know how old I am. My belly is starting to tell me how fat I am. My wife is telling me how slow and messy I am. My daughter-in-law is telling me I should have hired a contractor. And my foggy old brain and aching body are telling me they are all saying the right thing! My teenage ego, though, is telling me, "You can still do this!!!"

If things go well, I will take my first shower in my remodeled shower sometime between Christmas and New Year's Day...an event anticipated by my wife for more than 6 weeks now, especially since I assured her it would "...only take a couple of days."

And that is how you re-grout a shower floor.

Re: OT - How to re-grout a shower floor

#2

Thanks, Joe

David Yoho

Thanks for the heads up. All of a sudden that master bath floor tile grout isn't looking so bad to me!

Your account of the whole process had me laughing... not at you but at just the way things seem to work out sometimes. I mean how many of us have had the same thing happen with whatever it was around the house or garage. It starts off innocent enough, looks like a quick fix only to end up diving head first into a full-blown project. I've been there and bet most others reading this have too. That's why I found it funny but I feel your pain buddy. Hang in there!

Re: OT - How to re-grout a shower floor

#3

Re: OT - How  to re-grout a shower floor

Stuart Johnson

My story is very similar to yours without the nail in the drain and add termites and replacing several studs. The worst part is after ten years I now have a leak and can't figure out the source. Rebuilding the shower isn't on the top of my fun ways to spend time especially if it involves building a new pan.

Re: OT - How to re-grout a shower floor

#4

Re: OT - How  to re-grout a shower floor

John McGaw

I can really relate to that. I was going to do a repair in the en suite bath for the master bedroom for a long time. Then it came to pass that my elderly mother was going to need to come live with me so the need became pressing since the old bath was nasty and far from accessible. It wound up being a full to-the-studs-and-joists ripout including breaking up the old thick mud bed floor.

I decided that this was going to be a one-time process so I went the full Schluter route and used thick heavy porcelain tile. When the decision was made about the shower hardware I decided that the stainless shower bar with body sprays and all the bells and whistles was actually cheaper and easier than a conventional plumbing setup. I put in a Euro-look frameless glass door on the shower and added appropriate grab bars at places around the room along with a higher toilet.

Since I had the old ceiling come down (a long story and not a pretty one since I was in the attic above the bathroom at the time trying to get the old vent fan loose) I installed three LED pot lights for general lighting and one of the slick Panasonic automatic silent vent fans. Also put in a King heater since the bathrooms in this house have no heat ducts. I got it done a couple of weeks before Mom moved in but it was a real struggle and far more expensive than expected.

Re: OT - How to re-grout a shower floor

#5

Re: OT - How  to re-grout a shower floor

Barry Irby

Been there many times.....

Those metal nailing plates.....For years I thought the actual name of them was Idiot Clips. Everybody I dealt with in the construction business called them that. Yours is fine example of how it is so hard to make things Idiot Proof.

Yours is also an example of what I call "Going through life But First". I am going to fix the grout, but first maybe I should remove the tile...... all down hill from there.

Re: OT - How to re-grout a shower floor

#6

Thanks for the smile Joe

Dick Coers

Reminds me when I tried to fix a couple of spots on the facia. Ended up replacing the roof, well the roof after replacing some rotted roof sheeting. There has to be a name for this phenomenal growth in expenses in proportion to the minor intentions!

Re: OT - How to re-grout a shower floor

#7

Re: OT - How  to re-grout a shower floor

rfcomm2k

WOW, deja vu!

A customer called me about a leaky shower I had installed a year ago in their upstairs bath. After inspecting the shower (no problem found there) and cutting holes in ceiling below, I found the problem. a nail into a copper water line. It was driven just far enough to dent the pipe, then after about 10 years of galvanic action it finally developed a pinhole leak. This of course led to replacing the wall tile because wall behind was wet, and I found original tile job was done over ordinary drywall. So it all came out and hardiebacker went up. While I was doing this owner came in and asked what I could do to clean the grout and to remove the seat that was built into shower. I suggested removing it all and re-tiling would be cheaper labor wise than cleaning the grout lines and patching in tile where the seat was.

Removing seat was going to be easy, just a few pieces of framing lumber covered with plywood and then tiled over.

Not.

Seat was a stack of solid 6" x 12" x 16" concrete blocks mortared together and then tiled over. It took me 4 hours to finesse that out of there without damaging the surrounding wall tile or the subfloor.

Set a new mortar bed so water drained properly (had puddles before) and set new tile and grouted. Wonder what the guy was thinking when he made that seat, as his wife is a petite little thing that didn't need that much structure to support her in the shower.

Re: OT - How to re-grout a shower floor

#8

Re: OT - How  to re-grout a shower floor

Rum

Depressingly familiar, almost the exact same thing happened to me at our last house. I'll just scrape out the grout and we'll be done in a weekend.. Nope. Tile over regular drywall which was soggy 3' up and more next to the showerhead all new everything and working in the evenings took 3 weeks.

Or when we decided to replace the floor in the living room, which ended up being replace all the floors, add 1/4" underlay too the 80% of the house to bring them level with the one room we weren't (kitchen which had nice tile), oh and hey the old trim and doors don't go with the new floor so replace all those while we're here... Hmm all the floors and trim are out, might as well paint everything.. Pulled the outlet covers and faceplates to paint, oh look that was always miswired, check the wiring.. uuggghhhh.

Re: OT - How to re-grout a shower floor

#9

Re: OT - How  to re-grout a shower floor

John McGaw

It appears that tile over standard drywall was pretty much standard procedure in many areas. I had it in Alaska and here in Tennessee. Total insanity in my mind or possibly a matter of cheap builders having too much control over the codes and approval process. My little en suite shower was the most used in the house and the drywall behind the tile was a regular black mold farm up to the height of the first seam.. The mud bed had leaked at sometime in the past and the previous owner had someone come in and fit a sheet lead pan over the mud but they didn't do a thing about the water creeping up the walls.

Re: OT - How to re-grout a shower floor

#10

Ya know...

Tony - Memphis

I've never liked the molded bath & surround or the fake marble we have in our 1998 era house, but I do appreaciate that they don't leak! Gosh, what nightmares! The worst we have dealt with is moldy caulk.

At a house I lived in with my folks in high school, there was a window in my tiled shower. What a mess that was. Not sure when that house was built...this was aroun '88 and it had been around a while. I'm guessing 70's based on the ugly brown entry tile and foil wallpaper!

Tony

Re: OT - How to re-grout a shower floor

#11

Re: OT - How  to re-grout a shower floor

Jesse Cloud

Great story and it hit close to home.

You have clearly earned a nice long hot shower when you are done!!

Re: OT - How to re-grout a shower floor

#12

To do any project, you need to

mdclor

complete 6 other projects first. However, a VERY well told story is a joy to the audience. :)

Re: OT - How to re-grout a shower floor

#13

Re: OT - tile over drywall

Rum

Yeah drywall in the shower makes no sense to me at all, I won't even use green board in a direct water contact area although that would perhaps be marginally forgivable. Regular drywall ought to be a hanging offense, there is just no way it will ever work (disclaimer in that I'm ignoring waterproofing systems like kerdi or redguard which change the equation).

Re: OT - How to re-grout a shower floor

#14

Thank Goodness...

Bill Howatt

...an event anticipated by my wife for more than 6 weeks now, especially since I assured her it would "...only take a couple of days."

With such an entertaining tale of woe I was getting concerned you had not followed my basic rule on job timing. That is to double the planned time number and then go to the next larger unit of time. So your 2 days turns into a realistic 4 weeks and you are just a little bit slow on that number! Probably because you did such an excellent job.

I'd say we've all been there and know what you went through but if your wife ultimately is happy then it's all worthwhile.

Bill

Re: OT - How to re-grout a shower floor

#15

Re: OT - How  to re-grout a shower floor

Paul Blackwell

Wow, does that bring back memories! Shortly after we bought our house in Newark, NY, I got to looking at the ugly deck on the back of the house. I hadn't liked it when we bought, but everything else was good. It looked like it had been made from old chicken crates, so one Sunday morning I got out the tools and started tearing it off with the idea that I'd construct a nice low deck with plenty of space to relax on. As I started to remove the boards attaching it to the house, I realized that the original owners had built the deck and then put the clapboard siding on. I was left with large gaping areas with no siding. The clapboards in question were the masonite boards used maybe 40 or more years ago and were showing signs of deterioration. I ended up tearing off all the siding on the whole house and replacing it with cedar clapboards. I never have been a fan of vinyl. After this rather expensive detour, I turned my attention to the deck. I laid out the holes I had to dig for support, rented a two man gas powered auger and called a good buddy for help. Denny was a bear of a man, and so it began. The holes had to be 42" deep to meet code, and the drill had a 36" auger to start, and after getting that deep, you added an extension to complete the job. We had thirteen holes to dig in dry, hard stony clay soil. The auger constantly caught on stones, spun us around since there was no clutch, and eventually stalled. The temperature that day was well into the 90's, and we were soon exhausted. My wife looked out at one point and saw us both flat on our backs on the lawn. She thought we had both had a heart attack. With the extension attached, it was necessary to lift the unit high over our heads to clear the hole to move on. The vibration was taking it's toll on our muscles and it was increasingly harder to handle the auger. We completed 12 holes and were looking at the last. I asked Denny if he thought we could do it, and he said, "No, if we put that thing in the hole, we'll never get it out". I dug that one by hand the next day. Denny later told me that driving home in his standard shift truck, his arms were so done in from the vibration that he couldn't shift it out of first gear. In digging one of the holes, we struck the septic tank, and after some further exploration we found that the septic tank was under the corner of the deck. To allow clean-out, it had to be moved. When the contractor started in with the back hoe, he determined that the entire leach field was flooded and we ended up with not only a new septic tank, but also a new leach field. When I arrived home from work that day, the entire back lawn looked like a battlefield. There was not a blade of grass to be seen. I would have sold the house for a dollar about then. Of course we had to have a new lawn put in. There are no little projects.

Re: OT - How to re-grout a shower floor

#16

Re: OT - How  to re-grout a shower floor

Joe Pack

Bet that old deck wasn't so bad after all, was it? :-)