Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

cutting prefinished plywood

Posts

cutting prefinished plywood

#1

cutting prefinished plywood

Brad

I need to build some plywood cabinets and would like to prefinish one side of the full 4x8 sheets prior to cutting down. My understanding is polyurethane finishes will significantly dull carbide saw blades: is this correct? Thanks

Re: cutting prefinished plywood

#2

Re: cutting prefinished plywood

Steve Schoene

I can't imagine that it is very meaningfully correct, given the large usage of pre-finished ply in commercial cabinetry. It's a thin plastic resin, not something with abrasive characteristic.

Re: cutting prefinished plywood

#3

Re: cutting prefinished plywood

AZ in Colorado Springs

I think polyurethane will dull planer knives if one planes a board finished with polyurethane.

Re: cutting prefinished plywood

#4

Re: cutting prefinished plywood

Bob Lang

I wouldn't worry about it, just keep the "good" side up as you cut.

Bob Lang

Re: cutting prefinished plywood

#5

Re: cutting prefinished plywood

Jesse Cloud

I've cut quite a bit of prefinished on carbide blades without a noticeable amount of dulling. If you do a lot of it, check your blades every now and then to see if they need cleaning. There is a lot of crud in plywood and it will build up on your blades.

Re: cutting prefinished plywood

#6

Re: cutting prefinished plywood

Ron Pemberton

Or down if you are using a trak saw. "Good side" up on tablesaw, "good side" down with a trac saw or circular saw.

Re: cutting prefinished plywood

#7

Re: cutting prefinished plywood

Barry Irby

I don't think poly will significantly affect your saw blades.

OTOH, Paint that includes Titanium Dioxide (white body) is very hard and tough on blades.

Re: cutting prefinished plywood

#8

Re: cutting prefinished plywood

Royce Meritt

I've cut a great deal of prefinished plywood with my table saw and also haven't noticed any difference in dulling. Crud build-up is another story, although I doubt the finish has much more to do with that than the glue used to make the plywood. I know I don't clean my blades nearly often enough.

Re: cutting prefinished plywood

#9

Re: cutting prefinished plywood

Howard Acheson

<<<< My understanding is polyurethane finishes will significantly dull carbide saw blades: is this correct?

No, that is not correct. Contrary to popular belief, clear poly oil based varnishes are quite soft and, therefore not very abrasive. Softer finishes are more difficult to scratch

Re: cutting prefinished plywood

#10

Re: cutting prefinished plywood

TomD

As has been hinted at, you could get a poly build up on the top of the tooth, where it melts on. This reduces the clearance angle and in the worst case would be like having a blade that was a toothless disc. The teeth aren't dull, but you can't get the wood to them. So just keep an eye out for any build up.