Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

# Mortises in Breadboard End

Posts

# Mortises in Breadboard End

#1

# Mortises in Breadboard End

don stephan

Recently I finished a 30" wide tabletop with breadboard ends, incorporating 3 mortise-and-tenon pairs at each end. At the time, I was wondering if 4 or 5 pairs would have been more appropriate. The current issue of a woodworking magazine suggested more than 3 pairs in a 36" long breadboard end would weaken the end too much. If the tenons are 2 1/2 to 3 1/2" wide, there would seem to be more than enough solid wood between the mortises for strength, and extra tenons over a longer breadboard would seem better able to resist downward pressure on ends 2 1/2 to 3 wide. A 1/4" square or 3/8" square haunch the full length is not going to contribute strength to resist downward pressure, just help keep the breadboard end and table field in alignment. My inclination for a table 36" wide would be to use either 4 or 5 mortise-and-tenon pairs in each breadboard end. I'd appreciate hearing others' thoughts.

Re: # Mortises in Breadboard End

#2

Jack Guzman from Maine

Re: # Mortises in Breadboard End

Jack Guzman from Maine

In a table that size I would go with three tenons with a full length haunch.---Jack

Re: # Mortises in Breadboard End

#3

Ellis Walentine

Engineering

Ellis Walentine

Look at this in terms of function and aesthetics. Engineering-wise, three tenons are probably enough to withstand expected downward forces, but if five would look better to you (i.e., if you plan to have visible pins or plugs on the table top), I'd say go for it. I don't know how to tell you to calculate an optimal number of tenons, but any such calculation would take into account the tenon size and thickness, the strength and thickness of the species of wood you're using, and the resistance to deflection that the piece requires.

Ellis