Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

alluminum door

Posts

alluminum door

#1

alluminum door

Art demers

I have to take 1/4 in. off the bottom of the door I was thinking of using my router and a carbide bit a little at a time 1/16" 1/32" I don't know it's aluminum 1/2" thick. I could use a skill saw with a carbide blade has anybody ever done this??? thanks in advance

Re: alluminum door

#2

Re: alluminum door

Keith Newton

Yes, I have cut aluminum with a circular saw. Choose a low hook angle, eye protection and gloves. The chips are sharp and hot.

Re: alluminum door

#3

Re: alluminum door

Dick Coers

That's GOOD eye and hearing protection. It sounds like a train wreck and when they are hot, they stick! I like to spread (with a palette knife) a really thick layer of paste wax on the surface of the aluminum. It melts and lubricates the blade as you cut.

Re: alluminum door

#4

Re: alluminum door

John in NM

Like the other guys, I'd use a circ. saw with the right blade. I've done it with a router and it sucks. Horrible :D

With the circ saw, use good eye and ear protection. I like Dick's blade lube too, that sounds like a good idea. Since the one job I had where we used the router as a milling machine, I've always managed to avoid any aluminum I couldn't cut on my CSM. But then I can use a mill at work too, so I'm cheating :D

With a router, use a face shield over the eye protection, a ball cap or something to keep the hot chips out of your hair, a buttoned up shirt to keep them out of the back of your neck, and long sleeves with gloves duct taped at the wrist. Man am I glad I don't work anymore for the outfit that used to do this all the time! :D

If you do want to do it with the router anyway, cut it like a series of rabbets, increasing depth maybe 1/16 or less at a time. Assuming you use a clamped down base guide, this will keep your cuts more accurate. If you want a nicer finished surface, set the guide a bit shy of your mark to cut the bulk of it, then move the guide to the final mark and make a single full depth pass.