Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Delta Bearings

Posts

Delta Bearings

#1

Delta Bearings

Brad Bransky

Well, I received and installed the supposed great bearing guides "upgrade" for my 14" Delta BS.

What a colossal pain. It takes several minutes adjusting several nuts to accommodate each blade if it's a different width than the previous blade.

Stick with the cool blocks friends.

Brad

Re: Delta Bearings

#2

Re: Delta Bearings

del schisler

i belive the beiring guide could cause your blade to end up bad, if the beiring toutch's the teeth than blade is bad, i stick with the cool block's , mine delta is usa made and is 20 yrs or more , only had to change the tires , and adjust and that is all , with riser also,

Re: Delta Bearings

#3

Re: Delta Bearings

Barry Irby

I have not adjusted mine in a while so I may have forgotten, but I recall it being a pain in the butt. I don't want to mention them by name, but the name rimes with barter. They are rollers or ball bearings. It never occurred to me the adjustment would be to loosen the screw with an Allen wrench and let it flop about a bit and then re tighten it somewhere in the neighborhood. I really thought I would back off the screw, micro adjust a nob on the side and re tighten the set screw. Very expensive for what I got.

Re: Delta Bearings

#4

Re: Delta Bearings

Dick Coers

Wouldn't you only adjust two bearings when you change blades. The wheel doesn't change, so you only adjust the outside ones. I use a piece of paper as a feeler gauge when I adjust the Carter guides in my old Minimax. Not much of an issue for me.