Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

OT: Sealing Machined PVC Trim

Posts

OT: Sealing Machined PVC Trim

#1

OT: Sealing Machined PVC Trim

Henry Higginbotham

Sometime very soon I've got to rebuild a wall of 4' x 8' windows along my back porch. Some windows we replaced less than three years ago have rotting brick mold and sills, in spite of being prepped and painted pretty well, I thought.

I've had enough of that, so for the window wall I'm planning to encase the structural columns in solid PVC. As purchased, the PVC has a slick finish that probably will survive quite a while. But when you cut it with a saw, router, etc., it leaves a slightly porous surface, which looks like a great place to accumulate dirt, mold, or other grunge.

Some of the stop and faux muntins will have to be cut in this way. My Internet searches have so far turned up no suggestions for resealing, so I'm hoping someone here has done it (successfully). Anyone?

Re: OT: Sealing Machined PVC Trim

#2

Re: OT: Sealing Machined PVC Trim

George Koch

Henry, If this PVC is as dense as Azek brand, all we've ever done was to sand it down like you would do to end grain on lumber, although I know there are other brands that are much more porous. You might try coating a sample with a water based clear poly. George

Re: OT: Sealing Machined PVC Trim

#3

Re: OT: Sealing Machined PVC Trim

Henry (Raleigh NC)

No direct experience, but I always thought it was paint-able (check with manufacturer).. So you might be able to use a white (presumably) paint to seat the ends or machined surfaces.

Henry

Re: OT: Sealing Machined PVC Trim

#4

Re: OT: Sealing Machined PVC Trim

John McGaw

My only experience with standard PVC stock was ripped strips that had 3/4" exposed surface. I just primed the cut edge and then painted the whole pieces with standard exterior paint before installing it. I paint much better when standing in front of sawhorses in the garage rather than on a tall ladder so I always paint before installing whenever possible so that there is nothing to do beyond filling the nail holes.

Re: OT: Sealing Machined PVC Trim

#5

Re: OT: Sealing Machined PVC Trim

Keith Newton

Henry, I've never used the stuff before, so take this with a grain of salt. If they don't already have something specifically for this, I'd think about the UV cure Bondo. It comes as a nice creamy paste, which you can trowel on and fool with as long as you like, while in the shade. Then when you like what you've got, just put it out in the Sunshine for a while to cure.

Re: OT: Sealing Machined PVC Trim

#6

Re: OT: Sealing Machined PVC Trim

Henry Higginbotham

Thanks, everyone. It's claimed that the PVC trim doesn't have to be painted, as long as white is the color you want, and I'd hoped to get away with it. I was hoping, but not really expecting, that someone knew of something that would approximate the slick manufactured finish--some sort of mild solvent, maybe? I would guess the factory finish more likely involves heat and/or pressure.

But since only the stop and faux muntins will be cut this way, maybe I can get away with painting just those pieces. I'll report my success or failure.