Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Need source for chair bolt

Posts

Need source for chair bolt

#1

Need source for chair bolt

dIZD

Working on a chair repair for chairs that have 3/16" bolt reinforcing. I need the two 18" long bolts that run from the seat to the top of the curved rail. Called VanDykes - no luck - and did some searching on web. Do these things have a special name? They have smooth round head and threaded on bottom 2" or so. Similar to a carriage bolt but no square under the head. Anyone have a source for this? The chairs have chestnut seats so that dates them probably to first part of last century.

Re: Need source for chair bolt

#2

Re: Need source for chair bolt

Terry in Edmonton

One solution would be to use a piece of threaded rod. Some epoxy or thread locker to lock a nut to the head end and maybe some filing to make it look pretty.

Re: Need source for chair bolt

#3

Re: Need source for chair bolt

Barry Irby

If I understand what you are taking about, they sound similar to the bolts used under the treads in disappearing or pull down stairs. Bolts with a long thin shaft, round head and short threads. Not sure they do or don't have the square should under the head. Would the square should hurt you in your application? Never measured one, but they are about 16 to 18" long. Maybe a 3/16" or a quarter in diameter. Closer to 3/16 I think.

Just about every pull down stair I see has some loose ones on it.

Seems like McMaster-Carr would have such a thing. Or track down who makes pull down stairs and beg for help.

Re: Need source for chair bolt

#4

Or use acorn nuts and all thread rod.


Re: Need source for chair bolt

#5

Re: Need source for chair bolt

George Koch

My pull down attic stairs don't have them, but I have two wooden step ladders that have these rods below each tread. George

Re: Need source for chair bolt

#6

Thanks for ideas

dIZD

I think making some will be way to go - if I can find suitable steel rod.

Re: Need source for chair bolt

#7

Re: Thanks for ideas

Barry Irby

I had several thoughts.

If you could find a step ladder or pull down stair somebody was trashing, you might scavenge a couple of bolts out of them. (I had a ladder, but I think it might have been trashed already.)

There are fasteners, studs maybe, we used to call sex bolts that has a male half and a female half. One threaded into the other. Often used to hold books of samples together. Find the female half and get a rod that you can thread to screw into it. Then cut the rod the right length and thread the other end. IIRC some of these female bolts have slotted heads and some have not slots. These might be available at the borg in their drawers of odd parts.

Another thought is to get a rod and peen the end of it to make your own head and then thread the other end.