Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

wood tear out

Posts

wood tear out

#1

wood tear out

Jack Putnam

I am working on a floating wine bottle holder that requires two pieces of 1/2" Birch plywood that is cut about 5 inches tall and about 10 inches long. I am using a compound miter saw to cut the 45 degree angle that sits on the counter top and the wine bottle sits through a hole at the top of the bottle holder.

My question is when I put the two pieces of wood together to cut the 45 degree angle, the second piece of birch plywood has pieces of wood tear out where I cut the 45 degree angle. Could I be cutting the wood too slowly or not going fast enough. It's getting very frustrating it's happened twice now. Thanks for any help you can give me.

Re: wood tear out

#2

what blade and tooth count are you using?

Dick Coers

If you are using the blade that came with it, do an upgrade. Chop master by Forrest is my favorite.

Re: wood tear out

#3

Re: wood tear out

Ron Pemberton

If you don't a zero clearance insert on your miter saw, make one. I made one for my DeWalt and get splinter free cuts on Baltic Birch plywood.

Re: wood tear out

#4

Re: wood tear out

Lee Schierer in McKean, PA

Place painters tape or better still regular masking tape over the cut line before making the cut. The tape will help hold the edge fibers in place as the cut is made When removing the tape, pull the tape off toward the cut not away from the cut.

The zero clearance insert noted above is also essential in helping eliminate tearout.

Lee

Lee

Re: wood tear out

#5

Re: wood tear out

Jack Putnam

This text is for Lee Schierer in McKean, PA Thanks for the idea about the tape but I have a question. This might sound silly but what do you mean when you say zero clearance insert?

Re: wood tear out

#6

Re: wood tear out

Ron Pemberton

I am not Lee but I wii explane a zero clearance insert. Remove the insert on your miter saw. Double face tape the original insert on a piece of stock ( Baltic Birch, hardboard or a piece of hard wood), whatever matches the thickness of your insert. Trace the outline of the insert onto your stock. Bandsaw close to the line. If you have a router and a flush trim bit route around insert. No router, sand to the line. Install the new insert on your miter saw. Plunge the saw blade thru the insert. Viola, a zero clearance insert.

Re: wood tear out

#7

Or just put a scrap piece of plywood or mdf under

Keith Newton

the board being cut, just to back it up. This is easier than going to the trouble of cutting a replacement, which may fall apart after the first use.

Having a little downward pressure on the top may help too.

Re: wood tear out

#8

Re: wood tear out

Larry Clinton At Frankfort, (Central) Indiana

I have a Forrest Chopmaster blade on my saw, but even it will occasionally have a small amount of chipping on the workpiece. If I want a unblemished edge on the bottom of the cut I always use a sacrificial flat piece of scrap under my project board. Another issue I have had that took me a while to figure out is that the workpiece may "slide" a few thousands when I was making the cut. This caused miters to not be perfect. I applied 400 grit adhesive backed sandpaper (from Klingspor's) on the fence. The workpiece no longer is susceptible to moving and I have had no farther issues.