A little progress on the shop
Rob Sandow
I am sad to say it has been 8 years since I did any serious woodworking. There have been some home improvement projects and small craft projects, but no furniture, humidors, turning, etc.
In 2006, I lost my shop space, the 600+ sq ft attached garage at my old house. Most of my gear spent 2 years in storage and then eventually wound up in my new 400 sq ft detached garage at my new house. Not only was the old space much bigger, it also had ample power. While I had plans to turn the new space into a shop, there have been challenges. It is a detached garage that is over 50 feet from the main house and only has 1 15A 120V circuit. I had 4 tools that ran on 240V and one that requires a 120V 20A outlet. I need to get this upgraded. It has no heat and no gas feed. It is significantly smaller than my old space.
So I have made some adjustments. I sold my Williams & Hussey and my Powermatic 66 with 52" fence, luxuries I could no longer justify for space reasons, not to mention I could not power them up anyway. I still have some big tools that need 240V, but I am going to get that installed shortly. For a table saw, I have been getting by with a Ryobi job site saw, but that is not a long term solution. For the past 5 years, I have also been taking my guitar playing much more seriously, and for that reason, I have decided that my next table saw needs to be a SawStop.
Putting all of those things together, and also recognizing the need to replace the portability of my Ryobi job site saw, I have been trolling Craigslist for a SawStop contractor saw with 30" fence and portable wheel kit in my neck of the woods. This week, one popped up. So today, this came home with me (no I don't have a wide belt sander, the picture is from the shop of the guy who sold it to me). Hopefully, this will give me the kick in the pants I need to get the rest of the shop in shape.




