Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Anyone have issues with Triton routers

Posts

Anyone have issues with Triton routers

#1

Anyone have issues with Triton routers

Stephen Kirk

The above table adjuster and micro winder on my TRC001 started really grinding and got hard to move. Anyone experienced anything like this? I have a question into Triton as well.

Re: Anyone have issues with Triton routers

#2

Shot-In-The-Dark

Mark Mandell - Gone Round In New Jersey

Since I've had similar issues with my table-mounted router(Ryobi 3hp) I'll relate that the problem was caused by wood dust clogging up the guide posts. Took it out. Field-stripped and cleaned. Worked smoothly again.

Re: Anyone have issues with Triton routers

#3

Jim DeLaney, Austintown, Ohio

Re: Shot-In-The-Dark

Jim DeLaney, Austintown, Ohio

Sounds likely. I've had similar problems with my Router-Raizer equipped Hitachi M12V. I have to clean the gunk (technical term :D ) out of it every few months or so.

Re: Anyone have issues with Triton routers

#4

Re: Anyone have issues with Triton routers

Stephen Kirk

So I got the router apart and cleaned it up. The worm gear had a bit of dust, but it wasn't bad. The problem seemed to be that a shoulder on the worm gear shaft which rubs on a washer where it exits the plastic housing is starting to bind. I put a bit of lube on it, reassembled and now it's working well again. I'll just keep an eye on it. I used a bit of Slipit, but if I get some dry lube later I can out that on instead. I made sure there wasn't any other residue to capture dust.