Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Extreme router bits *Video* *LINK*

Posts

Extreme router bits *Video* *LINK*

#1

craigd

Extreme router bits *Video* *LINK*

craigd

Sorry 'bout the title but I found this [video] jaw dropping - using a run of the mill 5/16" round over bit on steel (he is making a 4' diameter spoked hand wheel). And it works well taking full depth cuts. Obviously not a wood router (running about 800 rpm) and not hand held but hand fed (sorta). In a later video, he chamfers rim using a full clamped set up and the cut is very clean. Using the same bit and only the bearing goes bad.

Start watching about about 5". Start at the beginning if you want to hear nice comments from a machinist about wood workers.


https://www.youtube.com/watch?v=WLoEiuosWCc