Anybody tried the Camo Deck screw system?
Barry Irby
I put new boards on my front stoop. Used the composite material. I stared at the Camo Screw system for a while and finally broke down and bought it. Discounted from about $90 to $47. Instead of about $8 worth of screws.
The system includes a "handle that has a driver mounted through it with a little indexing ridge one the foot that helps position the screw. You insert one of their special screws, position the driver, and with your drill attached to the top of the shaft, telescope the driver and "toenail" the screw in through the edge of the board. The instructions (yes, I actually read them carefully.) indicate it is made for pressure treated wood deck boards but is also suitable for composite material and hardwood. Supposedly designed for no space between the boards and invisible screws in the edges.
I decided to make a practice run. I had some scraps in the shop. I couldn't do anything with it. I could not make it drive a screw well. I decided the composite was too hard for the screws. Out of curiosity, I tried some treated wood boards. No better. (The treated wood was old and dry)
The screws look like trim screws, with small heads, about a 1/4" in diameter. The business end looks like they cut them off with a pair of pliers. I think they would have worked if the screws had a better drill point on them.
I gave up and went back to the old fashioned screws. Took the Camo things back and got my money back.
Anybody tried the Camo system and had better luck? Did I miss the secret?



