Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Shaker Candle Stand started w/pics

Posts

Shaker Candle Stand started w/pics

#1

Shaker Candle Stand started w/pics

Joe in a Cleveland suburb

I finally started making the Shaker Round Table/Candle stand for my daughter. It was supposed to be done a couple weeks ago; I am just now starting it...

I am using Walnut. My daughter likes Walnut. I'll be finishing it using (as close as I can get to) Bill Tindall's Walnut finishing technique. I used that for another table I made for her and she really really likes the look of the walnut using the technique.

So far I have the post pretty much ready for legs. I hope to start the legs next.

I spent most of the day last Saturday turning the post using my limited turning skills. I'm not too sure if I like turning a lot. I get bored quickly. I have the attention span of a flea and my mind starts to wonder while I'm doing it... which probably isn't too good.

Previously when I've made these little tables, while the post was still on the lathe, I've used my router to create a small flat for the legs. For this one I am thinking I'll either use a chisel or I'll cope(?) the leg to match the round of the post. Not sure. Creating the flat I think is easier, so I may do that.

Some pictures so far:

#1


#2 I bought the Walnut turning billets off eBay. They were supposedly 3" square. Not quite. At best 2-7/8". Mistake. Lesson learned.


#3


#4 Taking shape


#5 The pattern I use as I create the shape


#6


#7


#8 Pretty close. I sanded up to 180. Before the legs get attached, I'll hit it with 220.


#9 Getting ready to route the dovetails - wish my little lathe had a locking indexing mechanism


#10 Getting there


#11 Not too pretty of a setup, but it's functional


Thanks for looking at the progress so far.

:)

Re: Shaker Candle Stand started w/pics

#2

Re: Shaker Candle Stand started w/pics *LINK*

Tony - Memphis

Looking good! She'l be happy...and proud. Your dovetailing setup looks very similar to something I did for a plant stand. For reference, I have the same lathe. I bought this plate and have used it a lot. Once the pin is engaged, the piece is pretty steady.

Tony


http://alisam.com/page/1abxd/Woodworking_turning_OT.html

Re: Shaker Candle Stand started w/pics

#3

Off to a great start!