Samantha's dresser-16 applying final finish
Bill Tindall, E.Tn.
Finishing
Applying a finish to a piece of furniture has two purposes, and a bit of personal philosophy. The finish alters the appearance of the raw wood and the finish provides a protective barrier to the wood against physical and chemical(spills) damage. The finisher must optimize these two functions.
The school of minimalist finishing, the Krenov followers for example, focus on the appearance and largely ignore the protective role of the finish. This strategy can be successful for a wall cabinet that functions more as decorative art than furniture. A farm house oak floor with three coats of polyurethane could represent the other extreme. Furniture builders mostly find themselves between these extremes and we are forced into a compromise between appearance and durability, or even tradition in the case of reproduction work.
I found myself standing beside a magnificent mahogany pie crust table carved by one of the leading furniture reproduction craftsmen of the northeast. Other reproduction enthusiasts were also admiring the work when its maker showed up. Someone asked in more of a statement of fact than a question, “Is it French Polished”? “Oh, no”, the maker replied, “it’s polyurethane”. A gasp could be heard from the onlookers. He went on to explain that this table was made to be used in his household and hence it deserved a durable protective finish.
There are two conclusions from this tale. The first is to finish according to function. Second, appearance has more to do with the way the finish is applied than the chemistry of the film former. There was not a person among the onlookers that recognized this application of polyurethane from French Polished shellac.
I spray my finishes. It is fast and the result is glass smooth when done right. Ideal spraying conditions are a great assist to me doing it right. I like cool to facilitate leveling and dry to avoid water condensation.
PIC 1 spray gun

I use a DeVilbiss spray gun with a #30 cap. One is a type “MBC” and the other a “JGA”. They seem equivalent in my hands. They are commonly available used and they are inexpensive. They use a modest amount of air at 35 psi. For this project I am finishing with Sherwin William Kemvar “water white” (which means it is an aliphatic resin varnish not aromatic which will yellow in the sun) conversion varnish. It has a bright luster like shellac or lacquer. It is hard to resist scratches and it is resistant to household chemicals including water. We can wash furniture finished with this material. It may have been developed for kitchen cabinets.
Additionally, for this piece I want a close to the wood look. A thin film application achieves this appearance no matter the material applied. Hence, the finish is diluted 1 part xylene to 3 parts varnish.
PIC 2 scuff sanding
The weather the day I finished was an ideal 70 degrees in the AM. I applied the first wet coat of finish, allowed it to dry about an hour and then lightly sanded with 400 grit stearated paper. I prefer to hand sand at this step with a piece of folded paper and no pad. I want the paper to follow any contours of the surfaces.
PIC 3
After scuff sanding, the piece was blown off with compressed air and tacked with a tack rag. One final wet coat of thinned finish was added to the sides and 2 coats to the top to provide more protection. I want scratches to not penetrate the finish into the wood where they would be difficult to remove at some later time.
PIC 4 finishing the interior

Finally, the interior is finished with two coats of Zinser shellac, lightly sanded and waxed to provide a nearly frictionless travel for the drawers. Shellac is easy to apply, it dries quick and sands smooth.



