Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

OT – Plywood Underlayment Movement Question.

Posts

OT – Plywood Underlayment Movement Question.

#1

OT – Plywood Underlayment Movement Question.

DONinSTL

Does anyone know the dimensional stability of plywood underlayment?

I have a small bathroom floor area that is only 5 ft. x 5 ft. It is presently 3/8-inch plywood on top of 1/2-inch plywood sub-floor. It sits over a temperature controlled basement in the center of the house.

Before installing vinyl tile I will be installing a water resistant, plywood underlayment that is .2-inches thick. It will be stapled down with quarter-inch staples.

My question is, on a floor of this small size can I lay the underlayment tight against the ceramic wall tiles, without an expansion gap? Or, will there be enough movement in the underlayment that an expansion gap is absolutely necessary? I have reason to want to keep it as tight as possible.

Thanks for any help.

Re: OT – Plywood Underlayment Movement Question.

#2

Re: OT – Plywood Underlayment Movement Question.

Mark Mandell - Gone Round In New Jersey

Movement should not be a problem, however I question your staple job. Staples or nails in plywood is asking for s squeeky floor. Were it me, I'd make sure the two layers of ply were well screwed to the joists, then make sure you've got nothing proud, and finally glue down the surfacer (that.2" ply) so that you have no metal to work loose. If you have to, staple it to set the glue then remove the staples before putting down your tile.

Re: OT – Plywood Underlayment Movement Question.

#3

Re: OT – Plywood Underlayment Movement Question.

Keith Newton

Yes it should be OK to lay it tight. If you ever have a problem, it would likely be from a broken pipe or something, which would probably be a problem for anything.

Re: OT – Plywood Underlayment Movement Question.

#4

Glued & Screwed, otherwise...

robbcarr

...the staples will work loose and telegraph through the vinyl.

Re: OT – Plywood Underlayment Movement Question.

#5

Jason Roehl in Lafayette, IN

Never seen it.

Jason Roehl in Lafayette, IN

I've been in quite a few homes with sheet vinyl, and 1/4" underlayment is routinely stapled down in this area of the country. I've not seen a problem with staples telegraphing, nor have I heard squeaks that I would attribute to the underlayment. Staple away.

Jason

Re: OT – Plywood Underlayment Movement Question.

#6

Re: Never seen it.

Barry Irby

I have to agree with Jason on this. While it is a very good idea to screw and glue the subflloor to the joists and it would not hurt anything glue the underlayment, it is standard practice to staple it down, at least locally. I have personally done dozens of floors over the years and as a builder had hundreds done.

Locally they use 7/8" staples. In fact you can buy underlayment that is mark for the job. Four inch centers in a grid. A lot of staples. Two inch spacing on the edges. If it makes you feel better, glue it too, but I think its over kill.

Re: OT – Plywood Underlayment Movement Question.

#7

PS, its OK to lay it tight.....

Barry Irby

When they install vinyl over it they fill all the seems with flash patch which has the same effect as laying it perfectly tight.