Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

dremel saw blade

Posts

dremel saw blade

#1

dremel saw blade

Jack Putnam

I am working on a project carving out a six inch long mayfly. I need something to cut into the body to hold it's wings intact. Dremel tools is the only thing that comes to mind. They use to have a round small saw blade that would fit onto a Dremel power tool but I can't find them any ware. The wings are about 3/32 of an inch thick so I need something pretty small in thickness. Does anybody know of some kind of real small cutting tool that would do the job? Thanks for any help I can get.

Re: dremel saw blade

#2

Rick L

Re: dremel saw blade

Rick L

http://www.amazon.com/gp/aw/d/B009GLRKWK?pc_redir=1405355816&robot_redir=1

Here you go...

Re: dremel saw blade

#3

Re: dremel saw blade - HF?

Henry W

I just bought a Foredom tool and found some small saw blades at Harbor Freight (maybe 0.75 inch to 1.5 " diameter blades; kerf is unknown to me). The Foredom can be fit with a variety of collets, so these blades will work for me. I don't know what size 'bit' a Dremel needs, and so I can't promise the bit shank is the right size for the Dremel. I have not used these yet, I just know that I have them.

If you have a local HF and can lower your standards enough to enter the store ;) - this may be an option.

Henry

Re: dremel saw blade

#4

An abrasive disc will also cut a slot.


Re: dremel saw blade

#5

Re: dremel saw blade

Ralph Lipeles

Xacto makes very thin, fine toothed saw blades for use with Xactn knives.

Re: dremel saw blade

#6

Yikes ! . . .

steve mackay

I tried the saw blade once. Very,VERY hard to control and "at speed" (any speed) is pretty aggressive (for miniature work). I really didn't care for it. For slots try the different sizes of cut-off wheels. The light wheels give a paper thin slot. Move up to the "fibre", heavier cut-offs for a wider slot. For even wider slots I can "push" the wheel (gently) and use the side. If I intentionaly "wear" the wheel down (smaller diameter) I can get something along the lines of a "biscut" slot that will be hidden after assembly.

Re: dremel saw blade

#7

Possibly a mulitool

Lee Schierer in McKean, PA

I've seen blades for multi tools that are only 3/8" wide. The blades are only about 1/32" thick. Plunge cuts are pretty easy to control.

Lee