Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Samantha's Dresser 14-installing the pulls

Posts

Samantha's Dresser 14-installing the pulls

#1

Samantha's Dresser 14-installing the pulls

Bill Tindall, E.Tn.

Drilling holes in a drawer that has hours of labor in it is not a place to screw up. I am installing Lee Valley brass pulls on this piece and they are screwed on with 3" centers. I bias the pulls off center as the drawers get bigger and lower in the case. Starting with the top pull centered the off set increases at each drawer to be above center 3/8" at the bottom drawer.


A fool proof way of locating the holes is show as follows. I set one square for the distance in from the end of the drawer and another for the distance above the bottom and mark with an awl. The second hole is located with a divider set to the hole spacing, in this case 3".


To ensure I get the holes perpendicular I drill them on the drill press.


Re: Samantha's Dresser 14-installing the pulls

#2

Re: Samantha's Dresser pulls

Yonak

It's coming along, Bill. Ya gotta love that grain. I have two questions : When will we get to see the pulls ? and How did you get that tri square to balance on the end of the drawer face like that ? Great tips.

Re: Samantha's Dresser 14-installing the pulls

#3

Re: Samantha's Dresser 14-installing the pulls

Barry Irby

Interesting approach. I use a template. I make a piece of scrap the same size as the drawer front and layout the holes on it about the same way you do and drill them on the drill press, just as you do. Then I study it and if I am satisfied with it I clamp it to the drawer front and drill through it. Then move it to the next drawer. If the drawers are graduated, I rip the pattern down as I go. Once I have made the pattern I am much more comfortable drilling the drawers.

Re: Samantha's Dresser 14-installing the pulls

#4

PS, That is some gorgeous wood.


Re: Samantha's Dresser 14-installing the pulls

#5

Re: Samantha's Dresser pulls

Bill Tindall, E.Tn.

Gravity defying device to be revealed in future post. Admission, there were pleas to the photographer (LOML) to "hurry up"!

Re: Samantha's Dresser 14-installing the pulls

#6

Adam of Oakland

Re: Samantha's Dresser 14-installing the pulls

Adam of Oakland

This is a great tip, Mr. Tindall, thank you!

I'm really enjoying this build progression.

and yes to echo others' sentiments: spectacular wood selection, prep, finish. truly suprbe, maestro!