Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

A hobby that pays

Posts

A hobby that pays

#1

A hobby that pays

Bill Tindall, E.Tn.



The picture shows an English reproduction I recently scrutinized in a shop. It is a simple chest that many could build and most could build if they set their mind to learning the few things needed to build this piece. It was priced at $8,000. This quantity of money would buy most of the tools in my shop.

BTW, it has the dainty drawers characteristic of English drawers. The sides are but 1/4". To my surprise it has machine cut dovetails, something I have never seen in this shop before.

Another piece in this shop was a chest of drawers from about 1800. It had the tiniest half blind pins I have ever seen. They were only a saw width at the top and two saw widths at the bottom. No doubt the pin holes in the tail board were cut with saw only. Nobody owns a chisel that small. It is a fast way to make the tails in the oak drawer sides.

Re: A hobby that pays

#2

Re: A hobby that pays

Joe in a Cleveland suburb

I like the looks of it. Nice piece.

What am I seeing on the top of the case on either side of the top drawer? Are those arms that pull out? It looks like the top folds over. Correct?

Thanks.

Re: A hobby that pays

#3

Re: A hobby that pays

Bill Tindall, E.Tn.

It looks like the top folds over. Correct?....Yes

Though if I was to make this piece I would not make it with a folding top.

I do like the idea of its many smaller drawers.

Re: A hobby that pays

#4

I've been wondering...

Joe in a Cleveland suburb

about this post. What do you mean by "A hobby that pays".

The hobby of inspecting/looking at details of antiques and the payback being learning from them?

Thanks.