Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Craftsman plunge router

Posts

Craftsman plunge router

#1

Craftsman plunge router

Joseph Mulherin, sr

A bearing has gone sour inside and I need to remove the head of the motor to replace it. BUT, the screws holding the casing are so tight i cannot get them to release. Have tried "lock-ease" and some other tools to get them to loosen but no effect.......help please

Re: Craftsman plunge router

#2

Re: Craftsman plunge router *LINK*

Bob Entwisle in NJ

Hi Joesph,

My penetrating oil of choice is Kroil. It's far and beyond any other penetrating oil I've used for freeing up stuck parts.

I've heard, but not tried it, that a 50-50 mix of ATF and Acetone is also good for freeing up rusted parts etc.

Bob in NJ


http://www.kanolabs.com/

Re: Craftsman plunge router

#3

Re: Craftsman plunge router

Keith Newton

Have you tried an impact driver yet? Or are you just using a hand held screwdriver?

Re: Craftsman plunge router

#4

Re: Craftsman plunge router

Joseph Mulherin, sr

Yes, Keith, I have tried the impact screw driver...and the lock-ease. Am going to mix up the ATF and acetone and see if that works. Bearing only costs about $0.60 and I do not want to take the router to some repair shop for such a measly problem.

Re: Craftsman plunge router

#5

Re: Craftsman plunge router

Keith Newton

I understand I just changed them in my Makita 3612 last week. Sometimes heat will do a good job on loosening them. You could try a soldering iron, or micro torch an old bit while it is in the grooves.

Re: Craftsman plunge router

#6

Re: Craftsman plunge router

Howard Norman

My standard penetrating oil these days is the 50/50 mixture of ATF and acetone.

Re: Craftsman plunge router

#7

Re: Craftsman plunge router

Joseph Mulherin, sr

Tried it and it did not budge, so I am drilling out the screw head to get the motor head casing loose, will unscrew the remaining screw in the body and replace with a longer screw with a nut on top to reassemble after installing the new bearing

Re: Craftsman plunge router

#8

Re: Craftsman plunge router

Joseph Mulherin, sr

Ordered two new bearings....now just have to figure out how they are removed and then I shall reassemble.

It is a good router and I use it in my rockler table top effectively. Just need to figure out how to keep the dust from getting to the bearings again...some sort of shield will be made inhouse.

Re: Craftsman plunge router

#9

Re: Craftsman plunge router

Joseph Mulherin, sr

Tried to dismantle and found it was too delicate for this old man to do, so I am taking it to the Home Depot store in Palm Springs and Larry will do the work of replacing the bearings for me.

Re: Craftsman plunge router

#10

Re: Craftsman plunge router

Joseph Mulherin, sr

Reason that it is going to the shop is that the bearing is gaulded into the casing and some has melted down inside a little and is not readily accessable for me to do here at home. Profession help is needed...will cost some but the router is a good one and has done much work for me over the past 8yrs. Need it in the Rockler table to work on my future rocking chairs.