Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

3M glue residue

Posts

3M glue residue

#1

3M glue residue

Jack Putnam

I have asked a question about what type of glue I should use on a project I am working on using PVC pipe and rubber sheeting. I got an answer from Wood central to use contact cement. I made a test using 3M spray glue and contact cement on the PVC pipe and the rubber sheeting. It stayed out side for a month and the rubber sheeting using the contact cement did not come off of the PVC pipe where as the rubber sheeting came off the PVC pipe using the 3M spray glue.

Now my question is what can I use to take off the residue from the 3M glue on both the PVC pipe and the rubber sheeting so I can replace it with the contact cement it has to be clean as possible. Thanks for any help you can give me.

Re: 3M glue residue

#2

no need to remove

Bill Tindall, E.Tn.

just coat over it with contact cement. The bond likely failed because there was not enough glue. The contact cement will be happy to bond with the film on the pipe and rubber.

Re: 3M glue residue

#3

Re: 3M glue residue

Bob Entwisle in NJ

Jack,

Just a guess here, and you should test it first to make sure it doesn't cause problems with the PVC or rubber, but I'd try acetone.

Bob in NJ

Re: 3M glue residue

#4

Re: 3M glue residue

Barry Irby

I agree with both above. I think bill is right, that you don't really need to remove it and what you have will serve as a good primer. Most of my failures with Contact Cement have been from not applying enough. I use the No.77 Spray fairly often, but I have to discipline myself to apply it very liberally. Two or three coats. The stuff in the can is thicker (Like the difference between lacquer in a spray can and the type for brushing.) I have better luck with the stuff in the can, but still have to be certain to use a very heavy coat on both surfaces. Especially around the edges.

If you really want to remove it, lacquer thinner will wet it again and release it. (Have used it many times to remove Formica from the substrate.) It will be difficult to actually remove, but if you use enough thinner and rags or paper towels you can get it off. Not hard work, just messy.

Also, I don't think the lacquer thinner will hurt the PVC but you might test that. I am certain you could wet the PVC and the residual glue to reactivate it and apply more glue and move on, but you may not be able to soak it for a long period of time.

Use the glue that stinks of thinner, not the low odor water based stuff.

Re: 3M glue residue

#5

Ps....

Barry Irby

Timing is important. Let the glue dry until you can touch it gently with your fingers and it does not stick. It should have some visible thickness. If it looks like a coat of finish, its not thick enough.

And pressure is important. Use a roller to apply pressure or roll your PVC on a hard surface or even the narrow edge of a board. Maybe let it cure a while and roll it several times over a day or two. If you stick it too early, before it has dried to the right stage, it will eventually tick but you have to wait for the solvent to find its way out. Could be a slow process with rubber and PVC.